Mitsubishi Outlander (2003+). Manual — part 222
PROPELLER SHAFT
PROPELLER SHAFT
25-5
DISASSEMBLY AND REASSEMBLY
M1251001200238
AC203968
14
17
16 17
18 15 19
14
17
18
15
1
2
3
4
1
N
2
N
3
5
1
N
2
N
6
N
3
7
8
13
34 ± 5 N·m
12
11
10
N
187 ± 29 N·m
14
N
17
N
16
18
15
N
19
N
9
20
DOJ kit
DOJ boot kit
Universal joint kit
AD
187 ± 29 N·m
Disassembly steps
<<A>> >>G<<
1.
Snap ring
<<B>> >>F<<
2.
Journal bearing
>>F<<
3.
Journal
4.
Sleeve yoke
5.
Front propeller shaft
>>E<<
6.
Self locking nut
<<C>> >>E<<
7.
Centre yoke
<<D>> >>E<<
8.
Centre bearing assembly
<<D>>
9.
Bolt
>>D<<
10. Self locking nut
>>D<<
11. Companion flange
<<D>> >>D<<
12. Centre bearing assembly
Disassembly steps (Continued)
PROPELLER SHAFT
PROPELLER SHAFT
25-6
13. Centre propeller shaft
14. Snap ring
>>C<<
15. Boot band
<<E>> >>B<<
16. DOJ assembly
17. Rubber packing
<<F>>
>>A<<
18. DOJ boot
19. Washer
20. Rear propeller shaft
Disassembly steps (Continued)
PROPELLER SHAFT
PROPELLER SHAFT
25-7
Lubrication and Adhesive Points
AC203969
Repair kit grease:
Quantity: 95 ± 5 g
CAUTION
Rubber
mount
Do not refill or apply grease excessively.
Otherwise, faulty fitting of bearing caps and
errors in the selection of snap rings may
result.
Adhesive: 3M Stud Locking 4170 or
equivalent
AC
PROPELLER SHAFT
PROPELLER SHAFT
25-8
DISASSEMBLY SERVICE POINTS
<<A>> SNAP RING REMOVAL
Make mating marks on the flange yoke and propeller
shaft. Then, remove the snap rings.
<<B>> JOURNAL BEARING REMOVAL
CAUTION
Do not tap the journal bearings to remove them,
as this will upset the balance of the propeller
shaft.
1. Use special tool universal joint remover and
installer (MB990840) to press in the journal
bearing on one side, and take out the journal
bearing on the opposite side.
2. Insert special tool into the other side and press
the journal to remove the first journal bearing that
was pushed.
<<C>> CENTRE YOKE REMOVAL
Make mating marks on the centre yoke and centre
propeller shaft, and then remove the centre yoke.
<<D>>CENTRE BEARING ASSEMBLY/BOLT
REMOVAL
1. Make mating marks on the centre propeller shaft,
DOJ assembly and companion flange, and then
remove the bolt.
2. Use special tool bearing remover (MD998801) to
remove the centre bearing assembly from the
centre propeller shaft.
<<E>>DOJ ASSEMBLY REMOVAL
1. Remove the DOJ boot from the DOJ assembly.
ACX00645
Mating marks
AD
ACX00646AC
MB990840
MB990840
MB990840
MB990840
MB990840
AC003847
Mating marks
AD
AC101273
Centre bearing
assembly
MD998801
AD
AC101274
DOJ assembly
DOJ boot
AC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст