Mitsubishi Grandis. Manual — part 348
IGNITION SWITCH
CHASSIS ELECTRICAL
54A-11
DIAGNOSTIC TROUBLE CODE
PROCEDURES
Code No.11 Trouble related to the communication with ignition key
DIAGNOSIS CODE SET CONDITIONS
This code is set if the ID code is sent to the
immobilizer ECU from the ignition key when the
ignition switch is turned to the ON position.
POSSIBLE CAUSES
• Damaged harness wires and connectors
• Malfunction of ignition key
• Malfunction of immobilizer ECU
DIAGNOSIS PROCEDURE
Step 1. Check that the engine is started with
another registered ignition key.
Q: Is the check result normal?
YES :
Replace the ignition key that cannot start
the engine with new registered ignition key.
Refer to
NO :
Go to Step 2.
Step 2. MUT-III diagnosis code
Check that the immobilizer ECU sets a diagnosis
code.
Q: Is the diagnosis code set?
YES (diagnosis cede No.11 is set) :
Replace the
immobilizer ECU and register the ignition
key.
YES (diagnosis cede No.12 is set) :
Code No.12
The ignition key is unregistered or ID codes
do not match. Refer to
.
NO :
The procedure is complete.
Code No.12 The ignition key is unregistered or ID codes do not match.
DIAGNOSIS CODE SET CONDITIONS
This code is set when the ignition key is not
registered with the immobilzer ECU.
POSSIBLE CAUSES
• The ignition key is not registered with the
immobilzer ECU.
• Malfunction of immobilizer ECU
DIAGNOSIS PROCEDURE
Resister the encrypted code.
Q: Was the encrypted code registered?
YES :
The procedure is complete.
NO :
Replace the immobilizer ECU and register
the encrypted code. (Refer to
Ignition Key Ring and Immobilizer-ECU Circuit
HIGH-FREQENCY
CIRCUIT
POWER
SOURCE
IMMOBILIZER-
ECU
TRANSPONDER
IGNITION SWITCH
CHASSIS ELECTRICAL
54A-12
Trouble symptom chart
M1543007201321
CAUTION
During diagnosis, a diagnosis code associated
with other system may be set when the ignition
switch is turned on with connector(s)
disconnected. On completion, confirm all
systems for diagnosis code(s). If diagnosis
code(s) are set, erase them all.
Trouble symptom
Inspection
procedure No.
Reference page
Diagnosis code No.P0513 is set to the MPI system or the
immobilizer ECU cannot communicate with the MUT-III.
1
The ignition key cannot be registered with the MUT-III.
2
The engine does not start. (cranking occurs but initial
combustion does not)
3
Check the power supply and earth circuit to the immobilizer
ECU.
4
IGNITION SWITCH
CHASSIS ELECTRICAL
54A-13
SYMPTOM PROCEDURES
Inspection procedure: 1 Diagnosis code No.P0513 is set to the MPI system or the immobilizer ECU
cannot communicate with the MUT-III.
COMMENTS ON TROUBLE SYMPTOM
The immobilizer ECU communicates with the MUT-III
via the engine-ECU <M/T> or the engine-A/T-ECU.
The communication error between the immobilizer
ECU and the engine-ECU <M/T> or the
engine-A/T-ECU may be occurred.
Wire colour code
B : Black LG : Light green G : Green L : Blue
W : White Y : Yellow SB : Sky blue BR : Brown
O : Orange GR : Gray R : Red P : Pink V : Violet
ENGINE-ECU <M/T>
OR
ENGINE-A/T-ECU <A/T>
ENGINE
CONTROL
RELAY
IMMOBILIZER-
ECU
POWER
SOURCE
Immobilizer-ECU Power Source, Earth and Engine-ECU <M/T> or Engine-A/T-ECU <A/T> Communication Line Circuit
NOTE
: LH drive vehicles
: RH drive vehicles
IGNITION SWITCH
CHASSIS ELECTRICAL
54A-14
POSSIBLE CAUSES
• Malfunction of immobilizer ECU power supply
and earth
• Damaged harness wires between the
engine-ECU <M/T> or the engine-A/T-ECU and
the immobilizer ECU
DIAGNOSTIC PROCEDURE
Step 1. Connector check: Key reminder switch
connector C-308 and engine-ECU <M/T> or
engine-A/T-ECU <A/T> connector C-112
Q: Are key reminder switch connector C-308 and
engine-ECU <M/T> or engine-A/T-ECU <A/T>
connector C-112 in good condition?
YES :
Go to Step 2.
NO :
Repair the defective connector.
AC310615
AS
Harness side
Connector: C-112 <LHD>
C-112 (GR)
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
AC310628AW
Harness side
Connector: C-112 <RHD>
C-112 (GR)
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
AC310153AE
Connector: C-308 <LHD>
Harness side
AC310183
AE
Connector: C-308 <RHD>
Harness side
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст