Mitsubishi Montero Sport (2004+). Manual — part 452
DOOR
TSB Revision
BODY
42-63
NOTE: After inspecting intermediate connector C-39 inspect
the wire. If intermediate connector C-39 is damaged, repair or
replace damaged component. Refer to GROUP 00E
Harness Connector Inspection. Then go to Step 22.
Q: Are there any damaged harness wires between
ETACS-ECU connectors D-10 (terminals No.21 and
No.24) <Vehicles without keyless entry system> or D-27
(terminals No.41 and No.42) <Vehicles with keyless
entry system> and door lock actuator (front: LH)
connector F-12 (terminals No.4 and No.6)?
YES : Replace the ETACS-ECU and then go to Step 22.
NO : Repair or replace the damaged components. Refer to
GROUP 00E
, Harness Connector inspection.
Then go to Step 22.
STEP 6. Check door lock actuator (front: RH) connector
F-24 for loose, corroded or damaged terminals, or
terminals pushed back in the connector.
Q: Is the connector in good condition?
YES : Go to step 7.
NO : Repair or replace the damaged components. Refer to
GROUP 00E
, Harness Connector inspection.
Then go to Step 22.
AC309309AJ
CONNECTOR: C-39
C-39
AC309460
CONNECTOR: F-24
F-24
FRONT DOOR <RH>
AB
1
3 2
4
6 5
COMPONENT SIDE
DOOR
TSB Revision
BODY
42-64
STEP 7. Check the front door lock actuator switch (front:
RH).
(1) Remove the door latch assembly (Refer to
(2) Follow the table to check the resistance when the door lock
actuator (front: RH) is operated (lock/unlock).
Q: Is the front door lock actuator switch (front: RH)
damaged?
YES : Replace front door lock actuator assembly (front:
RH), go to Step 22.
NO : Go to Step 8.
LEVER
POSITION
BATTERY
CONNECTION
LEVER
OPERATION
At the "UNLOCK"
position
• Connect terminal
No. 4 and the
positive battery
terminal.
• Connect terminal
No. 6 and the
negative battery
terminal.
The lever moves
from the
"UNLOCK"
position to the
"LOCK" position.
At the "LOCK"
position
• Connect terminal
No. 6 and the
positive battery
terminal.
• Connect terminal
No. 4 and the
negative battery
terminal.
The lever moves
from the "LOCK"
position to the
"UNLOCK"
position.
ACX02351
LEVER
LOCK
UNLOCK
VIEW A
A
AC
DOOR
TSB Revision
BODY
42-65
STEP 8. Check ETACS-ECU connectors D-10 <Vehicles
without keyless entry system> and D-27 <Vehicles with
keyless entry system> for loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Q: Are ETACS-ECU connectors D-10 <Vehicles without
keyless entry system> and D-27 <Vehicles with keyless
entry system> in good condition?
YES : Go to Step 9.
NO : Repair or replace the damaged components. Refer to
GROUP 00E
, Harness Connector inspection.
Then go to Step 22.
AC202002
6 5 4
1
2
7
3
8
41
43
51
42
50
44
52
46 45
53
49
47
30
48
56
55
D-27 (B)
D-10
JUNCTION
BLOCK (REAR)
CONNECTORS: D-10, D-27
AB
D-27 COMPONENT SIDE
D-10 COMPONENT SIDE
21
22
23
24
25
26
27
28
DOOR
TSB Revision
BODY
42-66
STEP 9. Check the harness wire between ETACS-ECU
connectors D-10 (terminals No.21 and No.24) <Vehicles
without keyless entry system> or D-27 (terminals No.41
and No.42) <Vehicles with keyless entry system> and door
lock actuator (front: RH) connector F-24 (terminals No.4
and No.6).
AC202002
6 5 4
1
2
7
3
8
41
43
51
42
50
44
52
46 45
53
49
47
30
48
56
55
D-27 (B)
D-10
JUNCTION
BLOCK (REAR)
CONNECTORS: D-10, D-27
AB
D-27 COMPONENT SIDE
D-10 COMPONENT SIDE
21
22
23
24
25
26
27
28
AC309460
CONNECTOR: F-24
F-24
FRONT DOOR <RH>
AB
1
3 2
4
6 5
COMPONENT SIDE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст