Mitsubishi Pajero Pinin. Manual — part 232
REAR SUSPENSION –
Rear Suspension Assembly
34-5
LATERAL ROD BUSHING REPLACEMENT
1.
Use a press to press in and out the bushing.
2.
Apply ample amount of soapy water to the outer surface
of the bushing and inner surface of the lateral rod pipe,
and then press-fit the bushing so that both ends protrude
evenly.
UPPER ARM BUSHING/LOWER ARM BUSHING
REPLACEMENT
UPPER ARM REAR BUSHING, LOWER ARM REAR
BUSHING
1.
Use the special tools and a press to press in and out
the bushing.
SPECIAL TOOL
Item
Upper arm rear bushing
Lower arm rear bushing
A
MB990947
MB990947
B
MB990832
MB990831
C
MB990847
MB990847
D
MB991154
MB991155
2.
Apply ample amount of soapy water to the outer surface
of bushing and inner surface of arm pipe, and then press-fit
the bushing so that both ends protrude evenly.
UPPER ARM FRONT BUSHING, LOWER ARM FRONT
BUSHING
1.
Use a press and the special tools to press in and out
the bushing.
NOTE
Press in the bushing from the chamfered side of the arm
pipe.
2.
Install the bushing so that both ends protrude evenly.
A
Driving out
Press-
fitting
B
C
A
D
B
C
Upper arm
Lower arm
MB990958
MB990983
Bushing
Cham-
fered
portion
NOTES
REAR SUSPENSION –
General/General Information
34-1
GROUP 34
REAR SUSPENSION
GENERAL
OUTLINE OF CHANGE
The coil spring specification has been added. <5-door models>
The service procedures have been added due to the introduction of the rear stabilizer. <5-door models>
The bushing of the upper control arm has been reshaped.
GENERAL INFORMATION
COIL SPRING<5-door models>
Items
Specification
Wire diameter
average diameter
free length mm
11
131
305
CONSTRUCTION DIAGRAM
Upper control arm
Stabilizer link bracket
A
A
Section A–A
New
Old
Stabilizer link
Stabilizer bar
Bushing
Bushing
REAR SUSPENSION –
Service Specification/Special Tool/Stabilizer Bar
34-2
SERVICE SPECIFICATION
Items
Standard value
Stabilizer link ball joint turning torque Nm
1.7 – 3.1
SPECIAL TOOL
Tool
Number
Name
Use
MB990326
Preload socket
Stabilizer link ball joint turning torque measure-
ment
STABILIZER BAR
REMOVAL AND INSTALLATION
Post-installation Operations
Press the dust cover with your finger to check that
there are no cracks or damage in the dust cover.
4
1
2
1
3
5
49 Nm
44 Nm
44 Nm
83 Nm
Removal steps
1. Stabilizer link assembly
2. Stabilizer link bracket
A
3. Stabilizer bracket
A
4. Bushing
A
5. Stabilizer bar
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст