Mitsubishi Galant. Manual — part 603
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
52B-53
STEP 1. Check the side impact sensor (RH) line at the SRS-
ECU connector C-45 by backprobing.
(1)Do disconnect the side impact sensor (RH) connector D-09
(2)Connect the negative battery terminal.
(3)Turn the ignition switch to "ON" position.
(4)Measure the voltage between terminal 1 and the ground by
backprobing.
•
Voltage should be 9 volts or more.
(5)Check the continuity between terminal 3 and the ground by
backprobing.
•
Should be less than 2 ohm.
Q: Does the voltage meet the specifications or is the
resistance less than 2 ohm?
YES : Replace the side impact sensor (LH). Refer to
NO : Go to Step 2.
AC003696AB
D-09 CONNECTOR
HARNESS SIDE VIEW
AC003697AC
D-09 CONNECTOR
HARNESS SIDE VIEW
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
52B-54
STEP 2. Check the harness wires between SRS-ECU
connector C-45 and side impact sensor (RH) connector D-
09.
NOTE: After inspecting intermediate connector D-18, inspect
the wiring harness. If the intermediate connector D-18 is
damaged, repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 3. If harness
wires are in good condition, go to Step 3. If any harness wires
between SRS-ECU connector C-45 and side impact sensor
(RH) connector D-09 are damaged, repair them or install the
sensor cable. Refer to
Q: Are the harness wires between SRS-ECU connector C-
45 and side impact sensor (RH) connector D-09 in good
condition?
YES : Go to Step 3.
NO : Repair them. Then go to Step 3.
STEP 3. Check for DTC.
Q: Is DTC 94 output?
YES : Replace the SRS-ECU. Refer to
NO : This diagnosis is complete.(If no malfunctions are not
found in all steps, an intermittent malfunction is
suspected. Refer to GROUP 00, How to Use
Troubleshooting/Inspection Service Points
−
How to
Cope with Intermittent Malfunction.)
AC003195AD
CONNECTOR: C-45
CENTER
REINFORCEMENT
SRS-ECU
AC003211AB
CONNECTOR: D-09
AC003212AB
CONNECTOR: D-18
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
52B-55
SRS WARNING LIGHT CHECK
M1524004300071
1. Check that the SRS warning light illuminates when the
ignition switch is in the "ON" position.
2. Check that it illuminates for approximately 7 seconds and
then goes out.
3. If not, check for diagnostic trouble codes.
AC003188AB
SRS WARNING LIGHT
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
52B-56
SYMPTOM PROCEDURES
SYMPTOM PROCEDURES
M1524010300058
INSPECTION PROCEDURE 1: Communication with Scan Tool MB991502 is not Possible with the SRS
System Only.
AC000828AB
SRS-ECU Power Supply Circuit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст