Mitsubishi L200. Manual — part 225
ENGINE CONTROL
ENGINE AND EMISSION CONTROL
17-4
ACCELERATOR PEDAL
REMOVAL AND INSTALLATION
M1171003001238
CAUTION
• Never loosen the screw fixing the accelerator pedal assembly resin cover. If the screw is loos-
ened, the sensor position which exists inside the resin cover is off and the accelerator pedal posi-
tion sensor does not work normally.
•
Pre-removal and Post-installation Operation
Instrument Panel Driver’s Side Under Cover Removal and
Installation (Refer to GROUP 52A
− Instrument Panel ).
AC501727
13 ± 2 N·m
1
2
AD
3
13 ± 2 N·m
N
Removal steps
1.
Accelerator pedal position sensor
connector
2.
Accelerator pedal assembly
<<
A
>>
>>
A
<<
3.
Accelerator pedal arm stopper
Do not remove the accelerator pedal pad. If the pad is removed and installed, excessive force may
damage accelerator pedal position sensor.
REMOVAL SERVICE POINT
<<A>> ACCELERATOR PEDAL ARM STOPPER
REMOVAL
Remove turning the accelerator pedal arm stopper.
INSTALLATION SERVICE POINT
>>A<< ACCELERATOR PEDAL ARM STOPPER
INSTALLATION
AC600545AD
Accelerator
pedal arm
stopper
Stud bolt
Body
1. Insert the accelerator pedal arm stopper straight
into the stud bolt of the floor.
2. Install the accelerator pedal arm stopper securely
by turning it clockwise until its underside contacts
with the body as shown in the figure.
CRUISE CONTROL
ENGINE AND EMISSION CONTROL
17-5
3. After the installation, slightly pull the accelerator
pedal arm stopper by hand to check that it cannot
be removed easily (appropriate holding power:
100 N or more).
CRUISE CONTROL
GENERAL INFORMATION
M1172000101228
By using the cruise control system, the driver can
drive at preferred speeds in a range of approximately
40 to 200 km/h without depressing the accelerator
pedal.
For this cruise control system, in conjunction with the
common rail fuel control system, the engine-ECU
electronically controls the fuel injection system.
CONSTRUCTION DIAGRAM
AC711389
Stop lamp switch
Vehicle
speed sensor
Clutch switch <M/T>
Accelerator pedal
(Built-in accelerator
pedal position sensor)
AC
Fuel injection system
Inhibitor switch
<A/T>
Hydraulic unit
assembly
(integrated with
ASTC-ECU)
AC509982AG
Engine-ECU
<L H drive vehicles>
AC500966AJ
Engine-ECU
<R H drive vehicles>
AC509994 AC
A/T-ECU
<L H drive vehicles>
AC500965AJ
A/T-ECU
<R H drive vehicles>
AC801078AB
Cruise control
switch
AC900932
Cruise control
indicator lamp
AB
AC711565
AB
Diagnosis connector
<L H drive vehicles>
AC501596
AC
Diagnosis connector
<R H drive vehicles>
CRUISE CONTROL
ENGINE AND EMISSION CONTROL
17-6
CRUISE CONTROL
ENGINE AND EMISSION CONTROL
17-7
SPECIAL TOOLS
M1172000601740
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст