Mitsubishi Lancer Evolution 7. Manual — part 351
EXTERIOR -
Marks
51-21
(2) Three-diamond mark, (3) Evolution-VII mark
Press line
73 mm
23 mm
73 mm
134 mm
204 mm
247 mm
8.5 mm
Press line
Press line
View A
A
B
Vehicle centerline
Press line
Press line
Three-diamond
mark
73 mm
C
C
Section C-C
Vehicle centerline
14 mm
225 mm
58 mm
97 mm
151 mm
8.5 mm
3.5 mm
Press line
View B
Vehicle centerline
(4) Lancer mark
20 ± 1 mm
30 ± 1 mm
Trunk lid terminal
EXTERIOR -
Marks
51-22
(5) RECARO decal <RS-II>
RECARO decal terminal
52 mm
Stationary window
weather strip terminal
15 mm
31 mm
16 mm
RECARO decal terminal
16 mm
19 mm
28 mm
52 mm
Stationary
window glass
Stationary window
weather strip terminal
Stationary
window glass
Application tape terminal
Application tape terminal
<Right>
<Left>
2. Installation steps
(1) Remove grease on the marked surface of the
body with unlead gasoline.
(2) Peel off the protection sheet on the back of the
mark to paste it on the installation position.
Caution
1) Carry out the operation in a dust-free place where
the room temperature is between 20 and 38.
2) If the room temperature is below 20, heat the mark
and the body (pasted area) between 20 and 30.
3) Be sure to pressure the mark immediately after
the pasting is done.
EXTERIOR -
Outside Mirror
51-23
OUTSIDE MIRROR
SPECIAL TOOL
Tool
Number
Name
Application
MB990784
Ornament remover
Removal of power remote control outside
mirror switch
OUTSIDE MIRROR
REMOVAL AND INSTALLATION
1
2
3
4
6
7
1
Claw
A
A
Section A - A
5
A A
2
7.4 ± 1.4 N·m
Outside mirror removal steps
1. Cover
2. Delta inner cover
3. Outside mirror assembly
4. Outside mirror
A
A"
5. Mirror
Remote control outside mirror switch
removal steps
6. Instrument panel ornament (Refer to
GROUP 52A - Instrument Panel.)
7. Remote control mirror switch
EXTERIOR -
Outside Mirror
EXTERIOR -
Outside Mirror
51-24
REMOVAL SERVICE POINT
A
A" MIRROR REMOVAL
Tilt the mirror upward, insert the flat-tipped screw driver
wrapped around with the protection tape between the notch
located behind the mirror and pivot plate, and pry off the
mirror.
INSPECTIONS
REMOTE CONTROLLED MIRROR ASSEMBLY CHECK
<RS-II>
Battery connection terminal
Operation of mirror
1
2
3
Up
Down
Right
Left
THERMAL PRINTED WIRE FUNCTION CHECK
For vehicles with thermal printed wires, check that there is
continuity between terminals (1) and (4).
Section A – A
Notch
Flat-tipped
screw driver
Pivot plate
A
Mirror
Flat-tipped screw driver
A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст