Mitsubishi Outlander GS45X. Manual — part 1574
POWER STEERING HOSES
TSB Revision
POWER STEERING
37-59
>>D<< SUCTION HOSE INSTALLATION
1. Align the oil reservoir side suction hose marking within the
area shown in the figure and connect the suction hose.
2. Align the oil pump side suction hose marking within the area
shown in the figure and connect the suction hose.
AC612198AG
Marking
Suction hose
Oil reservoir
AC607830
AF
Suction hose
Marking
Oil pump
30˚
<2.4L Engine>
AC707955
AE
<3.0L Engine>
Marking
Oil pump assembly
Suction hose
NOTES
14-1
GROUP 14
ENGINE COOLING
CONTENTS
GENERAL INFORMATION . . . . . . . .
SERVICE SPECIFICATIONS. . . . . . .
COOLANT . . . . . . . . . . . . . . . . . . . . .
SEALANT. . . . . . . . . . . . . . . . . . . . . .
ENGINE COOLING DIAGNOSIS . . . .
INTRODUCTION. . . . . . . . . . . . . . . . . . . . .
TROUBLESHOOTING STRATEGY . . . . . .
SYMPTOM CHART. . . . . . . . . . . . . . . . . . .
SYMPTOM PROCEDURES . . . . . . . . . . . .
SPECIAL TOOLS. . . . . . . . . . . . . . . .
ON-VEHICLE SERVICE. . . . . . . . . . .
ENGINE COOLANT LEAK CHECK . . . . . .
RADIATOR CAP OPENING PRESSURE
CHECK . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGINE COOLANT CHANGE . . . . . . . . . .
WATER PUMP COOLANT LEAK CHECK .
ENGINE COOLANT CONCENTRATION
TEST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
COOLING FAN RELAY CONTINUITY
CHECK <2.4L ENGINE>. . . . . . . . . . . . . . .
FAN CONTROL RELAY CONTINUITY
CHECK <3.0L ENGINE>. . . . . . . . . . . . . . .
COOLING FAN MOTOR CHECK . . . . . . . .
THERMOSTAT . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<2.4L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<3.0L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
INSPECTION. . . . . . . . . . . . . . . . . . . . . . . .
WATER PUMP . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<2.4L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<3.0L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
WATER HOSE AND WATER PIPE . .
REMOVAL AND INSTALLATION
<2.4L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<3.0L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
INSPECTION. . . . . . . . . . . . . . . . . . . . . . . .
RADIATOR . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
<2.4L ENGINE>. . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION
GENERAL INFORMATION
TSB Revision
ENGINE COOLING
14-2
GENERAL INFORMATION
M1141000101750
The cooling system is designed to keep every part of
the engine at appropriate temperature in whatever
condition the engine may be operated. The cooling
method is of the water-cooled, pressure forced circu-
lation type in which the water pump pressurizes cool-
ant and circulates it throughout the engine. If the
coolant temperature exceeds the prescribed temper-
ature, the thermostat opens to circulate the coolant
through the radiator as well so that the heat
absorbed by the coolant may be radiated into the air.
The water pump is of the centrifugal impeller type
and is driven by the drive belt from the crankshaft
<2.4L ENGINE>. The water pump is of the centrifu-
gal impeller type and is driven by the timing belt from
the crankshaft <3.0L ENGINE>. The radiator is the
corrugated fin, cross flow type.
CONSTRUCTION DIAGRAM
<2.4L ENGINE>
AC808973AB
Radiator lower hose
Radiator
condenser tank
assembly
Radiator upper hose
assembly
Radiator assembly
CVT fluid cooler
feed hose assembly
Radiator fan
motor
Condenser fan
motor
Fan shroud
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст