Mitsubishi Lancer. Manual — part 221
FENDER
BODY
42-6
FENDER
REMOVAL AND INSTALLATION
M1421001900302
Pre-removal and Post-installation Operation
• Front Bumper Removal and Installation (Refer to GROUP
51, Front Bumper
• Front Deck Garnish Removal and Installation (Refer to
GROUP 51, Windshield Wiper and Washer
• Side Air Dam Removal and Installation <Vehicles with
side air dam> (Refer to GROUP 51, Side Air Dam
AC300491
AC304753
AC303863
Clip
Section A – A
AB
A
A
1
2
3
3
4
Note
: Clip positions
Removal steps
1. Splash shield
<<
A
>> >>
A
<< 2. Side turn-signal lamp
3. Delta outer garnish
4. Fender
Removal steps (Continued)
FENDER
BODY
42-7
REMOVAL SERVICE POINT
<<A>> SIDE TURN-SIGNAL LAMP
REMOVAL
AC005980
AC005980
Front of vehicle
Side turn-signal lamp
MB990784
AB
Use special tool ornament remover (MB990784) to
prize out the tab from the fender, and remove the
side turn
− signal lamp.
INSTALLATION SERVICE POINT
>>A<< SIDE TURN-SIGNAL LAMP
INSTALLATION
AC005719
Fender panel
Hook
Claw
Fender panel
: Front of vehicle
AE
Engage the claw with the fender panel, and install
the side turn-signal lamp.
FUEL FILLER LID
BODY
42-8
FUEL FILLER LID
REMOVAL AND INSTALLATION
M1421002500277
Pre-removal and Post-installation Operation
• Rear Seat Removal and Installation (Refer to GROUP
52A, Rear Seat
• Front Scuff Plate (Driver's Seat Side), Rear Scuff Plate
(Driver's Side), Centre Pillar Lower Trim (Driver's Side),
Quarter Trim (Driver's Side) Removal and Installation
(Refer to GROUP 52A, Trims
18M0109
W0570AQ
AC005996
AC005973
3
5
4
3
2
1
5.0 ± 1.0 N·m
AC
Fuel filler lid height and clearance
adjustment
Removal steps
1.
Fuel filler lid panel assembly
2.
Clip
3.
Fuel filler lid hook assembly
4.
Fuel filler lid lock release cable
5.
Fuel filler lid lock release handle
Removal steps (Continued)
STRUT TOWER BAR
BODY
42-9
STRUT TOWER BAR
REMOVAL AND INSTALLATION
M1421005600091
AC304680AB
Strut tower bar
44 ± 5 N·m
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст