Dodge Dakota (ND). Manual — part 896
4. Remove and discard the steering wheel bolt (4).
5. Remove the steering wheel (3).
INSTALLATION
NOTE: Do not reuse the old steering wheel bolt (4)
(a new bolt must be used)
NOTE: Make sure to align the spline on the steer-
ing wheel hub to the column shaft.
1. Install steering wheel (3) to the column (6).
NOTE: Be certain that the steering wheel mounting
bolt is tightened to the proper torque specification
to ensure proper clockspring operation.
2. Install the new steering wheel bolt (4). Tighten the
bolt to 61 N·m (45 ft. lbs.).
3. Install the driver’s side air bag (3) to the steering
wheel. (Refer to 8 - ELECTRICAL/RESTRAINTS/
DRIVER AIRBAG - INSTALLATION).
19 - 24
COLUMN
ND
STEERING COUPLING SHAFT
REMOVAL
1. Disconnect the negative battery cable.
2. Lock the steering wheel with the tire in the straight
position.
3. Remove and discard the upper pinch bolt (2) from
the upper coupling at the cloumn (1).
4. Lower the steering coupler shaft (3) from the col-
umn (1).
5. Remove the toe plate (6) nuts (5).
6. Remove and discard the lower coupler pinch bolt
(4) from the lower steering coupling shaft (3).
ND
COLUMN
19 - 25
7. Remove the steering coupling shaft (3) from the
vehicle.
INSTALLATION
1. Install the upper steering coupling shaft (3) to the
vehicle.
NOTE: Note: A new steering coupling shaft pinch
bolt for the upper and lower shafts must be used.
2. Install the upper coupling (7) to the column (1).
3. Install the upper pinch bolt (2) use a new bolt and
tighten to 38 N.m (28 ft.lbs).
4. Install the toe plate (5) nuts (6) and tighten to 12
N.m (105 in.lbs).
5. Install the shaft (1) to the lower coupling (2).
6. Install the lower pinch bolt (4) use new bolt and
tighten to 38 N.m (28 ft.lbs).
7. Unlock the steering wheel.
8. Reconnect the negative battery cable.
19 - 26
COLUMN
ND
LOWER STEERING COUPLING
REMOVAL
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Lock the steering wheel with the tire in the straight position.
4. Remove and discard the lower coupling (2) upper
pinch bolt (4).
5. Remove and discard the lower coupling (2) pinch
bolt (1).
6. Remove the lower steering shaft coupling (2) from
the steering gear (3).
ND
COLUMN
19 - 27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст