Dodge Durango (HB). Manual — part 1391
HINGE
REMOVAL
NOTE: It is not necessary to remove the liftgate to
replace one or both hinges. The hinges can be
replaced one at a time.
NOTE: A suitable body sealant should be used
when removing or moving the hinges.
1. Support liftgate on a suitable lifting device.
2. Using a trim stick C-4755 or equivalent, remove the
upper rear headliner trim.
3. Using a grease pencil or equivalent, mark the loca-
tion of the hinge to aid installation.
4. Remove the liftgate bolts (2).
5. Remove the body bolts (1) and remove the hinge.
HB
LIFTGATE
23 - 77
INSTALLATION
NOTE: A suitable body sealant should be used
when removing or moving the hinges.
1. If necessary, paint replacement hinge before instal-
lation.
2. Install the hinge (2) and install the body bolts (1).
3. Tighten the bolts to 28 N·m (21 ft. lbs.).
4. Install the liftgate bolts (2) and tighten to 28 N·m
(21 ft. lbs.).
5. Adjust liftgate if necessary. (Refer to 23 - BODY/
DECKLID/HATCH/LIFTGATE/TAILGATE/LIFTGATE
- ADJUSTMENTS)
6. Position the upper rear headliner trim and seat
fully.
23 - 78
LIFTGATE
HB
STRIKER
REMOVAL
1. Open the load floor, remove the scuff plate screws
and remove liftgate trim scuff plate.
2. Remove screws attaching liftgate striker to floor
pan (1) and remove the striker.
INSTALLATION
1. Install the striker (2) and install the bolts (1).
2. Tighten the bolts to 28 N·m (21 ft. lbs.).
3. Adjust the striker if needed. (Refer to 23 - BODY/
LIFTGATE/LATCH STRIKER - ADJUSTMENTS)
4. Install the liftgate trim scuff plate and install the
screws.
HB
LIFTGATE
23 - 79
ADJUSTMENTS
ADJUSTMENT
1. Using a grease pencil or equivalent, mark the posi-
tion of the striker (2) to aid in adjustment.
2. Loosen the striker bolts (1).
3. Change the striker position to adjust the lower lift-
gate gap and flush measurement. (Refer to 23 -
BODY/BODY STRUCTURE/GAP AND FLUSH -
SPECIFICATIONS)
4. Tighten the bolts to 28 N·m (21 ft. lbs.).
23 - 80
LIFTGATE
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст