Dodge Durango (HB). Manual — part 1394
LINER-QUARTER PANEL
DESCRIPTION
ISOLATORS-BODY
REMOVAL
1. Remove all cab to frame mounting bolts (3) and
rebound cushions (2).
QUARTER PANEL LINER
1 - C-PILLAR
2 - QUARTER PANEL LINER
3 - PLASTIC RIVET (5 PER SIDE)
HB
EXTERIOR
23 - 89
2. Remove the front end sheet metal mounting bolt
(2).
3. Using a floor jack and block of wood under the cab
sill, lift the body to gain access to the isolators.
4. Remove the cab isolators (1 above) and the front
end sheet metal mounting isolator (3).
5. Install new isolators and repeat steps one through
4, for the opposite side.
INSTALLATION
1. Install the isolators (1) rebound cushions (2), and
bolts (3).
2. Install the front end sheet metal mounting isolators
(1 & 3) and install the bolt (2).
3. Tighten the bolts to 81 N·m (60 ft. lbs.).
23 - 90
EXTERIOR
HB
FENDER
REMOVAL
1. Remove the grille. (Refer to 23 - BODY/EXTERI-
OR/GRILLE - REMOVAL)
2. Remove the headlight assembly. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
-
EXTERIOR/
HEADLAMP UNIT - REMOVAL)
3. Remove the wheelhouse splash shield. (Refer to
23 - BODY/EXTERIOR/FRONT WHEELHOUSE
SPLASH SHIELD - DESCRIPTION)
4. Remove the cowl grille. (Refer to 23 - BODY/EX-
TERIOR/COWL
GRILLE
AND
SCREEN
-
REMOVAL)
5. When servicing the right side fender, remove the
battery tray (1) and air cleaner bolts (2) from the
front end sheet metal (3).
6. When servicing the left side fender, remove the
power distribution center bolts (1) from the front
end sheet metal (2).
HB
EXTERIOR
23 - 91
7. Remove the two bolts from the fender behind the
wheel.
8. Remove the bolt from inside the wheel well.
9. Remove the bolts from the headlamp opening.
23 - 92
EXTERIOR
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст