Dodge Durango (HB). Manual — part 1379
5. Separate the links (3 & 5) from the clips (1 & 4)
and remove the lock cylinder (2).
INSTALLATION
1. Install the links (3 & 5) into the clips (1 & 4) and
install the lock cylinder (2) into the exterior handle.
2. Connect the electrical connector (1), and position
the handle (2) onto the door.
3. Install the nuts (4) and tighten to 5 N·m (45 in.
lbs.).
HB
DOOR - FRONT
23 - 29
4. Connect the links (1 & 3) to the latch (4).
5. Position the rear glass run channel back and install
the nut and bolt.
6. Tighten the fasteners to 8 N·m (70 in. lbs.).
7. Install the watershield. (Refer to 23 - BODY/DOOR
- FRONT/WATERSHIELD - INSTALLATION) (Refer
to 23 - BODY/DOOR - FRONT/WATERSHIELD -
INSTALLATION)
8. Adjust the latch as needed. (Refer to 23 - BODY/
DOOR - FRONT/LATCH - ADJUSTMENTS)
CYLINDER-LOCK
REMOVAL
1. Remove the exterior handle. (Refer to 23 - BODY/
DOOR
-
FRONT/EXTERIOR
HANDLE
-
REMOVAL)
2. Remove the screw and remove the lock cylinder
(2).
23 - 30
DOOR - FRONT
HB
INSTALLATION
1. Install the lock cylinder (2) and install the screw.
2. Install the exterior handle. (Refer to 23 - BODY/
DOOR - FRONT/EXTERIOR HANDLE - INSTALLA-
TION)
CHANNEL-GLASS
REMOVAL
1. Raise the glass to the full up position.
2. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
3. Remove the nuts (2) and disconnect the electrical
connector (3), if equipped.
4. Remove the side view mirror (1).
HB
DOOR - FRONT
23 - 31
5. Separate the inner belt molding from the mounting
flange from the rear to the front.
6. Insert special tool #9093 (2) between the outer belt
molding (1) and glass at the rear.
7. Push down on outer belt molding (1) and rotate
upper part of tool (2) outward from vehicle then lift
up on molding (1) to disengage from locking tabs
(3) working from back to front.
NOTE: Typical outer belt molding design shown.
8. Remove the nut (2) and bolt (3) and remove the
rear glass run channel (1).
9. Remove the bolts (6 & 5) and remove the front
glass run channel (4).
INSTALLATION
1. Install the front glass run channel (4) and install the
bolts (6 & 5). Tighten the bolts to 8 N·m (70 in.
lbs.).
2. Install the rear glass run channel and install the nut
and bolt.
3. Tighten the fasteners to 8 N·m (70 in. lbs.).
4. Position the inner and outer belt molding onto the
door and seat fully.
23 - 32
DOOR - FRONT
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст