Dodge Durango (HB). Manual — part 1378
GLASS
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
2. Separate the inner belt molding from the mounting
flange from the rear to the front.
3. Insert special tool #9093 (2) between the outer belt
molding (1) and glass at the rear.
4. Push down on outer belt molding (1) and rotate
upper part of tool (2) outward from vehicle then lift
up on molding (1) to disengage from locking tabs
(3) working from back to front.
NOTE: Typical outer belt molding design shown.
5. Slide molding out from under the side view mirror
and remove.
6. Temporarily install the window switch and position
the glass (1) to gain access to the regulator nuts
(4).
7. Remove the nuts (4) and remove the glass (1).
INSTALLATION
1. Position the glass into the door and install onto the
regulator.
2. Install the nuts (4) and tighten to 9 N·m (80 in.
lbs.).
3. Position the outer belt molding onto the door and
position forward under the side view mirror. Seat
the molding fully.
4. Position the inner belt molding onto the door and
seat fully starting at the back of the door.
5. Install the watershield. (Refer to 23 - BODY/DOOR
- FRONT/WATERSHIELD - INSTALLATION)
HB
DOOR - FRONT
23 - 25
REGULATOR-WINDOW
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
2. Temporarily install the window switch and position
the glass (1) to gain access to the regulator nuts
(4).
3. Remove the nuts (4).
4. Secure the glass in the up position using a wood
wedge or equivalent.
5. Remove the bolts (2) and loosen the remaining
regulator bolts.
6. Separate the regulator (2) from the door panel (1)
and disconnect the electrical connector (3).
23 - 26
DOOR - FRONT
HB
INSTALLATION
1. Position the regulator (2) into the door (1) and con-
nect the electrical connector (3).
2. Position the regulator bolts into the keyhole slots
and slide into place.
3. Install the remaining regulator bolts (2).
4. Tighten the bolts to 9 N·m (80 in. lbs.).
5. Position the glass (1) onto the door regulator (3).
6. Install the nuts (4) and tighten to 9 N·m (80 in.
lbs.).
7. Install the watershield. (Refer to 23 - BODY/DOOR
- FRONT/WATERSHIELD - INSTALLATION)
HB
DOOR - FRONT
23 - 27
HANDLE-EXTERIOR
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
2. Remove the bolt (3) and nut (2) and position aside
the rear glass run channel (1).
3. Disconnect the links (1 & 3) from the latch (4).
4. Remove the nut (4), the handle (2) and disconnect
the electrical connector (1).
23 - 28
DOOR - FRONT
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст