Dodge Ram Truck 1500-2500-3500. Manual — part 1952
7. On Quad Cab models, install the rear seat (1)
(Refer to 23 - BODY/SEATS/SEAT - INSTALLA-
TION).
8. On Quad Cab models, install the rear cup holder
(2).
9. If equipped, position the rear storage compartment
(2) onto the rear cab trim panel (4) and install the
three bolts (1). Tighten the bolts to 6 N·m (55 in.
lbs.).
10. If equipped, install the floor console (Refer to 23 -
BODY/INTERIOR/FLOOR CONSOLE - INSTAL-
LATION).
11. Install the front seats (Refer to 23 - BODY/SEATS/
SEAT - FRONT - INSTALLATION).
COAT HOOK
REMOVAL
1. Using a trim stick C-4755 or equivalent, disengage
the release clip (2) as shown and remove the coat
hook (1) from the headliner (3)
23 - 162
INTERIOR
DR/DH
INSTALLATION
1. Position the coat hook (1) through the headliner (3)
and fully seat the base of the support to the roof
panel.
2. Engage the release clip (2).
COWL TRIM
REMOVAL
1. Using a trim stick C-4755 or equivalent, disengage
the retaining tabs of the cowl trim panel (1) from
the retainer clips (2) in the door sill (3).
2. Pull the cowl trim panel rearward and remove it
from the vehicle.
DR/DH
INTERIOR
23 - 163
INSTALLATION
1. Position the cowl trim panel (1) onto the door sill
(2).
2. Push the cowl trim panel forward and then engage
the retaining tabs that secure the sill trim panel to
the rear door sill.
FLOOR CONSOLE
REMOVAL
1. If equipped, remove the 4WD gear shift boot (Refer
to 23 - BODY/INTERIOR/4WD FLOOR SHIFT
BOOT - REMOVAL).
2. If equipped with a manual transmission, remove
the transmission gear shift lever extension.
3. Using a trim stick C-4755 or equivalent, disengage
the retaining tabs that secure the manual transmis-
sion gear shift boot or storage bin (2) (depending
on application) to the floor console (4) and remove
the boot or storage bin.
4. Remove the three inserts (1 and 3) from the floor
console.
23 - 164
INTERIOR
DR/DH
5. Remove the three bolts (3) that secure the floor
console (2) to the floor panel.
6. Lift up the rear of the floor console to clear the
gear shift lever (4), if equipped.
7. Slide the floor console rearward and remove it from
the instrument panel (1).
INSTALLATION
1. Position the front of the floor console (2) under the
instrument panel (1).
2. Lower the back of the floor console over the gear
shift lever (4) (if equipped) and install the three
screws (3). Tighten the screws to 6 N·m (55 in.
lbs.).
DR/DH
INTERIOR
23 - 165
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст