Dodge Ram Truck 1500-2500-3500. Manual — part 1927
REAR
1. Raise the window glass to the full up position and
remove the window regulator (Refer to 23 - BODY/
DOORS
-
REAR/WINDOW
REGULATOR
-
REMOVAL).
2. Remove the two bolts (2) that secure the rear glass
run channel (1) to the door and remove the run
channel through the door panel opening.
3. If required, remove the weatherstrip from the rear
glass run channel.
INSTALLATION
FRONT
1. If removed, install the weatherstrip onto the front
glass run channel (2).
2. Position the front glass run channel into the door
through the door panel opening.
3. Install the two bolts (1) that secure the front glass
run channel to the door. Tighten the bolts to 10
N·m (89 in. lbs.).
4. Install the window regulator and verify correct win-
dow operation (Refer to 23 - BODY/DOORS -
REAR/WINDOW REGULATOR - INSTALLATION).
23 - 62
DOORS - REAR
DR/DH
REAR
1. If removed, install the weatherstrip onto the rear
glass run channel (1).
2. Position the rear glass run channel into the door
through the door panel opening.
3. Install the two bolts (2) that secure the rear glass
run channel to the door. Tighten the bolts to 10
N·m (89 in. lbs.).
4. Install the window regulator and verify correct win-
dow operation (Refer to 23 - BODY/DOORS -
REAR/WINDOW REGULATOR - INSTALLATION).
HINGE
REMOVAL
NOTE: It is not necessary to remove the door to replace the hinges if they are replaced one at a time.
NOTE: The epoxy coated washers should not be removed from the hinge. If the washers are removed the
door may have to be re-adjusted.
1. Open the front door
DR/DH
DOORS - REAR
23 - 63
UPPER HINGE
1. Using a grease pencil or equivalent, mark the posi-
tion of the hinge (2) on the door and b-pillar.
2. Remove the nut (1) and bolt (9) attaching the hinge
(2) to the door.
3. Remove the three bolts (6) attaching the hinge to
the b-pillar and remove the hinge.
23 - 64
DOORS - REAR
DR/DH
LOWER HINGE
1. Using a grease pencil or equivalent, mark the posi-
tion of the hinge on the door and b-pillar.
2. Remove the lower b-pillar trim. (Refer to 23 -
BODY/INTERIOR/B-PILLAR
LOWER
TRIM
-
REMOVAL)
3. Remove the nut (1) and bolt (9) attaching the hinge
to the door.
4. Remove the two bolts (5) attaching the hinge to the
b-pillar.
5. From the inside of the vehicle remove the remain-
ing bolt (4) attaching the hinge to the b-pillar and
remove the hinge.
DR/DH
DOORS - REAR
23 - 65
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст