Dodge Ram Truck 1500-2500-3500. Manual — part 1928
INSTALLATION
UPPER HINGE
1. Install the hinge to door washers, if there were
removed previously, nut (1) and bolt (9) and tighten
to 28 N·m (21 ft. lbs.).
2. Tighten the upper hinge bolt (2) to 28 N·m (21 ft.
lbs.).
3. Tighten the upper hinge bolt (1) to 28 N·m (21 ft.
lbs.).
4. Tighten the upper hinge bolt (3) to 28 N·m (21 ft.
lbs.).
5. Adjust the door if needed. (Refer to 23 - BODY/
DOORS - REAR/DOOR - ADJUSTMENTS)
23 - 66
DOORS - REAR
DR/DH
LOWER HINGE
1. Install the hinge and install the b-pillar bolts.
2. Tighten the upper hinge bolt (2) to 28 N·m (21 ft.
lbs.).
3. Tighten the upper hinge bolt (1) to 28 N·m (21 ft.
lbs.).
4. Tighten the upper hinge bolt (3) to 28 N·m (21 ft.
lbs.).
5. Install the hinge to door washers, if there were
removed previously, nut and bolt and tighten to 28
N·m (21 ft. lbs.).
6. Adjust the door if needed. (Refer to 23 - BODY/
DOORS - REAR/DOOR - ADJUSTMENTS)
7. Install the lower b-pillar trim. (Refer to 23 - BODY/
INTERIOR/B-PILLAR LOWER TRIM - INSTALLA-
TION)
DR/DH
DOORS - REAR
23 - 67
INTERIOR HANDLE ACTUATOR
REMOVAL
1. Remove the door trim panel (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - REMOVAL).
2. Position the waterdam out of the way and discon-
nect the actuator rod (2) from interior door handle
actuator (3).
3. Remove the two bolts (1) that secure the interior
door handle actuator to the door and remove the
actuator.
INSTALLATION
1. Position the interior door handle actuator (3) onto
the door.
2. Install the two bolts (1) that secure the interior door
handle actuator to the door. Tighten the bolts to 10
N·m (89 in. lbs.).
3. Connect the actuator rod (2) to the interior door
handle actuator.
4. Reposition the waterdam and install the door trim
panel (Refer to 23 - BODY/DOORS - REAR/TRIM
PANEL - INSTALLATION).
23 - 68
DOORS - REAR
DR/DH
LATCH
REMOVAL
1. Raise the window to the full up position and
remove the door trim panel (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - REMOVAL).
2. Position the waterdam out of the way and discon-
nect the actuator rod (1) from the interior door han-
dle actuator (2) and the door latch (5) and remove
the rod.
3. Disconnect the two actuator rods (3 and 4) from
the door latch.
4. Disconnect the door wire harness connector (2)
from the door latch (3).
5. Remove the three bolts (4) that secure the door
latch to the door (1) and remove the latch.
DR/DH
DOORS - REAR
23 - 69
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст