Dodge Ram Truck 1500-2500-3500. Manual — part 70
4. Align master splines and slide front and rear half-shafts together. Reposition slip yoke boot (4) and install new
clamp (3).
5. Install propeller shaft in vehicle.
ADJUSTMENTS
Launch shudder is a vibration that occurs at first acceleration from a stop. Shudder vibration usually peaks at the
engines highest torque output. Shudder is a symptom associated with vehicles using a two-piece propeller shaft. To
decrease shudder, lower the center bearing in 1/8 inch increments. Use shim stock or fabricated plates. Plate stock
must be used to maintain compression of the rubber insulator around the bearing. Do not use washers. Replace the
original bolts with the appropriate increased length bolts.
UNIVERSAL JOINTS-SINGLE CARDAN
DISASSEMBLY
DISASSEMBLY - WITH INJECTED RING
1. Place shaft yoke in vise.
2. Position U-joint press (1) with receiver (2) on pro-
peller shaft yoke.
3 - 112
PROPELLER SHAFT
DR/DH
3. Pressed U-joint bearing caps (1) out of shaft yoke
(2).
4. Remove lower bearing cap from shaft yoke.
5. Turn shaft over and position press (1) with receiver
(2) on shaft yoke.
6. Press remaining U-joint bearing cap out of shaft
yoke.
DR/DH
PROPELLER SHAFT
3 - 113
7. Remove flange (1) with U-joint out of shaft yoke
(2).
8. Position U-joint press (2) with receiver (1) on
flange.
3 - 114
PROPELLER SHAFT
DR/DH
9. Press U-joint bearing caps (1) out of flange (2).
10. Remove bearing cap on the outside of the flange.
11. Position U-joint press (2) with receiver (1) on
flange.
12. Press remaining U-joint bearing cap out of flange.
13. Remove U-joint from flange.
DR/DH
PROPELLER SHAFT
3 - 115
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст