Dodge Ram Truck 1500-2500-3500. Manual — part 71
DISASSEMBLY - WITH SNAP RINGS
1. Tap outside of bearing cap with a drift to loosen
snap ring.
2. Remove snap rings (1) from both sides of yoke.
3. Position yoke with the grease fitting if equipped,
pointing up.
4. Position a socket (2) with a inside diameter large
enough to receive the bearing cap, beneath the
yoke on a press.
5. Place another socket with an outside diameter
smaller than bearing cap on the upper bearing cap
and press (1) the lower cap through the yoke.
3 - 116
PROPELLER SHAFT
DR/DH
NOTE: If the bearing cap will not pull out of the
yoke by hand after pressing, tap the yoke ear near
the bearing cap to dislodge the cap.
6. Pull bearing cap of the yoke.
7. Turn yoke over in the press and straighten the
cross (1). Press the cross until the remaining bear-
ing cap (2) can be removed.
CAUTION: If cross or bearing cap are not straight
during removal, the bearing cap will score the
walls of the yoke bore and damage can occur.
ASSEMBLY
ASSEMBLY - WITH INJECTED RING
NOTE: Replacement joint has internal snap rings.
1. Place joint in flange with one bearing cap.
2. Position press (3) with receiver (1) on flange and
bearing cap (2).
DR/DH
PROPELLER SHAFT
3 - 117
3. Press bearing cap until snap ring groove (1) is
through the flange (2).
4. Install snap ring (2) on bearing (1).
3 - 118
PROPELLER SHAFT
DR/DH
5. Position press (3) with receiver (2) on remaining
bearing cap (1) and flange.
6. Press bearing cap until snap ring groove is through
the flange.
7. Install snap ring (1) on bearing cap (2).
DR/DH
PROPELLER SHAFT
3 - 119
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст