Dodge Ram Truck 1500-2500-3500. Manual — part 1587

31. Install new reverse shift fork (1) snap ring (2) with

the flat side facing rearward.

32. Install reverse gear (3), bearing (5), wave washer

(2) and brass blocker ring (1) on mainshaft (4).

33. Install reverse gear (1) thrust washer (2) and snap

ring (4).

.

21 - 280

MANUAL TRANSMISSION - T56 - SERVICE INFORMATION

DR/DH

34. Install mainshaft (3) roller bearing (4), spacers (2)

and snap ring.

35. Apply Mopar

T

Gasket Maker to tail housing seal-

ing surface.

36. Install the six tail housing (1) to case bolts (2) and

tighten bolts to 41 N·m (30 ft. lbs.).

37. Install two tail housing nuts (2) on top of transmis-

sion tail housing (3).

DR/DH

MANUAL TRANSMISSION - T56 - SERVICE INFORMATION

21 - 281

38. Slide offset lever (1) onto shaft in tail housing (2).

.

39. Install offset lever (3) roll pin with hammer (1) and

punch (2)..

40. Install Mopar

T

Gasket Maker to the shift cover

sealing surface and position cover on the trans-
mission.

41. Install shift cover four mounting bolts and tighten

to 18 N·m (13 ft. lbs.).

INSTALLATION

1. Slide transmission back into the clutch and seat

against clutch housing.

2. Install transmission bolts to clutch housing bolts

and tighten to and tighten bolts to 35 N·m (26 ft.
lbs.)

3. Install transmission crossmember (2) and bolts/nuts

(1). Tighten nuts to 61 N·m (45 ft. lbs.).

21 - 282

MANUAL TRANSMISSION - T56 - SERVICE INFORMATION

DR/DH

4. Install transmission mount (2) bolts (1) and tighten

to 41 N·m (30 ft. lbs.).

5. Remove transmission jack.

6. Install back up lamp switch (2) connector (1).

7. Install fuel line to top plate stud.

8. Install reverse lockout solenoid (1) harness connec-

tor (2).

DR/DH

MANUAL TRANSMISSION - T56 - SERVICE INFORMATION

21 - 283