Dodge Caliber. Manual — part 1284
2. Position the locating tab (1) of the terminal body as
shown and install the terminal body into the trans-
axle case.
3. Install the control valve assembly (1) up from the
bottom side and install it into the transaxle case.
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 435
4. Align the notch (1) of the pulley ratio linkage with
the sheave position sensor (2).
CAUTION: Apply CVT fluid when installing the
bushing.
5. Install the bushing (1) into the control valve
assembly.
21 - 436
AUTOMATIC - CVT-SERVICE INFORMATION
PM
6. Torque the mounting bolts of the control valve body
assembly to 8 N·m (70 in.lbs).
7. Install the manual lever (1) onto the manual shaft.
Install and torque the mounting nut to 22 N·m (16
in. lbs.).
PM
AUTOMATIC - CVT-SERVICE INFORMATION
21 - 437
8. Install the bracket (1) onto the control valve assem-
bly. Install and tighten the mounting bolts to 8 N·m
(70 in. lbs.).
CAUTION: Do not re-use the o-ring. Apply CVT
fluid when installing the o-ring.
9. Install the new o-ring (1) onto the new oil strainer.
21 - 438
AUTOMATIC - CVT-SERVICE INFORMATION
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст