Dodge Caliber. Manual — part 43
4. Install the four retaining nuts (2).
5. Raise the center support into position (1).
PM
SHAFT-PROPELLER
3 - 47
6. Install the two mounting bolts (3) and torque to 41
N·m (30 lbs.ft.).
7. Torque the four retaining nuts (2) to 47 N·m (35 ft.
lbs.).
3 - 48
SHAFT-PROPELLER
PM
8. Install heat shield (2) and torque the retaining nuts
and torque to 21 N·m (15 ft. lbs.).
9. Check fluid levels starting with PTU.
PM
SHAFT-PROPELLER
3 - 49
MODULE-REAR DRIVELINE
TABLE OF CONTENTS
page
page
MODULE-REAR DRIVELINE
SPECIAL TOOLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79
SEAL-INPUT FLANGE
SEALS-OUTPUT FLANGE
3 - 50
MODULE-REAR DRIVELINE
PM
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст