Dodge Caliber. Manual — part 42
SHAFT-PROPELLER
TABLE OF CONTENTS
page
page
SHAFT-PROPELLER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46
PM
SHAFT-PROPELLER
3 - 43
SHAFT-PROPELLER
REMOVAL
1. Raise the vehicle on the hoist.
2. Mark (2) prop shaft and differential (3) for proper
installation.
3. Remove the four rear prop shaft to rear axle retain-
ing nuts (2).
3 - 44
SHAFT-PROPELLER
PM
4. Remove the three bolts (3) from the center support
heat shield (2).
CAUTION: Propeller shaft removal. Never allow
propeller shaft to hang while connected to Power
Transfer Unit (PTU), rear driveline module flanges
or center bearings. If propeller shaft section is
hung unsupported, damage may occur to joint,
boot and/or center bearing from over-angulation.
This may result in vibration/balance issues. A
helper may be needed.
5. Remove the heat shield (2).
6. Remove the two center support mounting bolts (3)
PM
SHAFT-PROPELLER
3 - 45
7. Remove the propeller shaft (1).
INSTALLATION
CAUTION: Propeller shaft installation. Never allow
propeller shaft to hang while connected to Power
Transfer Unit (PTU), rear driveline module flanges
or center bearings. If propeller shaft section is
hung unsupported, damage may occur to joint,
boot and/or center bearing from over-angulation.
This may result in vibration/balance issues. A
helper may be needed.
1. Make sure transaxle is in Neutral (N) position.
2. Obtain a helper if needed and lift propeller shaft
assembly into position. Install propeller shaft spline
into PTU.
3. Align index marks (2) on propeller shaft with marks
on rear axle flange, slide propeller shaft over studs
on rear axle flange.
3 - 46
SHAFT-PROPELLER
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст