Dodge Caliber. Manual — part 1322
4. Remove sock seal (1) and (3) that wraps around
switch bezel and wire harness. Disconnect wire
connectors (2).
5. Remove switch bezel from bolster.
6. Remove bolster by unsnapping plastic tethers (1)
from bolster back side of surface.
INSTALLATION
1. Connect bolster to door module tethers (1).
PM
DOOR - FRONT
23 - 25
2. Connect wire connectors (2) and close sock seal
(1).
3. Replace window crank (1) to spindle.
4. Replace pull cup screw.
23 - 26
DOOR - FRONT
PM
FRONT DOOR GLASS
REMOVAL
1. Remove bolster. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - REMOVAL)
2. Move glass to line up snap plates with access
holes (1).
3. Using a punch or equivalent, press tabs releasing
glass from window regulator.
4. Manually move glass upward to full up position and
remove from window frame.
PM
DOOR - FRONT
23 - 27
INSTALLATION
1. Insert glass into glass channel and slide down
ensuring access holes (1) align with snaps.
2. Ensure access holes properly lock into snaps (1).
3. Install bolster. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - INSTALLATION)
23 - 28
DOOR - FRONT
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст