Dodge Caliber. Manual — part 1323
FRONT DOOR INSIDE HANDLE
REMOVAL
1. Unsnap link rod to latch (1).
2. Remove screw (3) attaching plate to panel.
3. Unsnap housing snaps from (2) belt line ribs on
trim panel.
4. Pull up on trim panel belt line to aid in unsnapping
of housing.
INSTALLATION
1. Snap inside handle to belt line ribs (2) on trim
panel.
2. Install screw (3) attaching handle to panel.
3. Snap link rod to latch.
PM
DOOR - FRONT
23 - 29
FRONT DOOR LATCH
REMOVAL
1. If equipped, disconnect wire harness from Latch.
2. Disconnect inside hand link (5) and lock rod (6)
from latch (4).
3. Unscrew latch presenter or unsnap latch from
presenter.
INSTALLATION
1. Move glass to the full up position.
2. Install latch assembly into door face (1).
3. Connect hand link (5) and lock rod (6) into latch.
4. Install fasteners and torque to 9 N·m (7 ft. lbs.)
ADJUSTMENTS
FRONT DOOR LATCH ADJUSTMENT
1. Insert a Torx
T
-wrench through the elongated hole in the door end frame near the latch striker opening.
2. Loosen Torx
T
head screw on the side of the latch linkage.
3. Push button on outside door handle and release it.
4. Tighten Torx
T
head screw on latch.
5. Verify latch operation.
23 - 30
DOOR - FRONT
PM
FRONT DOOR WINDOW REGULATOR
REMOVAL
1. Remove bolster. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - REMOVAL)
2. Remove door plugs. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - REMOVAL)
3. If equipped, remove window crank (1).
4. Remove glass. (Refer to 23 - BODY/DOOR -
FRONT/DOOR GLASS - REMOVAL)
5. Remove power motor attachment screws (1) from
front side of trim panel. (For manual windows only,
unsnap manual drive from drum housing).
PM
DOOR - FRONT
23 - 31
6. Remove lower attachment bolts through front side
of trim panel for Window Regulator rails (7).
7. Disconnect wire harness (10) from power motor on
back of trim panel.
8. Remove rails for towers on back side of trim panel.
9. Remove window regulator (5) from trim panel.
INSTALLATION
1. Install window regulator (5) to door module (6).
2. Install rails (5) back to trim panel.
3. Connect wire harness (10).
23 - 32
DOOR - FRONT
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст