Dodge Caliber. Manual — part 40
8. Remove the left side stay bracket bolts (1).
9. Remove the right side stay bracket bolts (1).
10. Remove the exhaust system up to the catalytic
converter. (Refer to 11 - EXHAUST SYSTEM/
MUFFLER - REMOVAL)
11. Support the rear driveline module with a transmis-
sion jack.
PM
HALF SHAFT-RIGHT REAR
3 - 35
12. Remove the rear bolt (1) at the driveline module.
13. Remove the two side bolts (1) at driveline module
(3).
3 - 36
HALF SHAFT-RIGHT REAR
PM
14. Lower driveline module enough gain access to the
electrical connector and bracket.
15. Remove the routing bracket bolt.
16. Unplug the electrical connector (1).
17. Lower the drive line module (1).
18. Disengage axle shaft (2).
19. Remove wheel if necessary.
20. Remove nut and washer halfshaft to left rear hub.
21. Remove half shaft from rear hub, if hard to
remove, or sticking, use a punch and hammer to
tap out.
PM
HALF SHAFT-RIGHT REAR
3 - 37
INSTALLATION
1. Lift driveline module (1) with a transmission jack
while installing halfshaft (2).
2. Install nut and washer halfshaft to left rear hub and
torque to 244 N·m (180 ft.lbs.).
3. Connect the electrical connector (1).
4. Install wire harness bracket and two mounting bolts
and torque to 45 N·m (33 ft. lbs.).
3 - 38
HALF SHAFT-RIGHT REAR
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст