Dodge Caliber. Manual — part 1176
7. Remove drain plug (2) at PTU and allow fluid to
drain.
8. Reinstall drain plug.
9. Mark (2) prop shaft and differential (3) for proper
installation (if equipped).
10. Remove the rear prop shaft (if equipped) (Refer to
3 - DIFFERENTIAL & DRIVELINE/PROPELLER
SHAFT - REMOVAL).
PM
POWER TRANSFER UNIT
21 - 3
11. Remove the two exhaust to maniverter (exhaust
manifold with catalytic converter) bolts (1).
12. Unplug the downstream O2 sensor connector.
13. Remove the exhaust system (Refer to 11 -
EXHAUST SYSTEM/MUFFLER - REMOVAL).
14. Lower the vehicle on the hoist.
15. Unplug the upstream O2 sensor connector.
16. Remove upstream O2 sensor from the maniverter
(exhaust manifold with catalytic converter) using
02 sensor socket 8439 (2).
21 - 4
POWER TRANSFER UNIT
PM
17. Remove the four maniverter heat shield bolts (1).
18. Remove the two retaining bolts (2) and one nut
(1) from the maniverter side heat shield (3).
PM
POWER TRANSFER UNIT
21 - 5
19. Remove the seven maniverter to head retaining
bolts.
20. Slide the maniverter up and to the right, The sup-
port the maniverter (1) with the help of a bungie
cord.
21. Raise the vehicle on the hoist.
22. Remove the four (1) engine to maniverter bracket
bolts.
21 - 6
POWER TRANSFER UNIT
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст