Dodge Caliber. Manual — part 1354
13. Release the lumbar mat side wires (1) by pulling
out on the wire supports and then pulling them in.
14. Squeeze the lower support wires (1) in and
release the lower wires.
15. Pull the upper support wires (1) down and release
the lumbar mat from the seat back frame.
PM
SEATS
23 - 153
ASSEMBLY
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/SEATS - WARNING)
2. Place lumbar mat onto seat back frame and insert
the upper support wires (1) into the frame.
3. Squeeze the lower support wires (1) together and
insert into the lower frame.
23 - 154
SEATS
PM
4. Squeeze the side support wires together and insert
them into the sides of the seat back frame.
5. Connect the lumbar cable housing (1) and connect
the cable end (2) to the anchor.
6. Install the lumbar adjuster and install the adjuster
screws (1).
PM
SEATS
23 - 155
7. Position the seat back cushion on the frame and
position the cover over the cushion.
8. Attach the seat cover (3) to the seat back cushion
(1) and install new hog rings (2) as required.
9. Install the push pins (1) and connect the inner
cover to the hooks (2).
10. Install the push-pin fasteners (2) and connect the
J-straps (1).
23 - 156
SEATS
PM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст