Lifan 620. Manual — part 16
37. DTC: P1651, Malfunction Indicator Light Control Circuit Trouble (see Table 1-50)
Table 1-50
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to ON.
Next
step
Yes Next
step
2
Carry out action tests for the MIL of the engine with a
3
4
65
Section IV
Steps for Trouble Diagnosis Based on Engine Symptom
Before the steps for trouble diagnosis based on engine symptom, carry out the following primary
checks at first:
66
I. LF481Q3 engine
1. If the engine fails to run or runs slowly at start, carry out the trouble diagnosis and removal as
per Table 1-51.
Table 1-51
S/N Operation Test
Results
Actions
Yes Next
step
1
Measure the voltage between the two terminals of the
battery with a multimeter. Is the voltage about
10-12.5V?
No
Repair or replace battery
2
3
4
5
6
7
67
2. If the engine can not be successfully started, carry out the trouble diagnosis and removal as per
Table 1-52.
Table 1-52
S/N Operation Test
Results
Actions
Yes
Remove the trouble
1
Turn the ignition switch to ON. Check if there is
trouble information records with a diagnostic
instrument.
No Next
step
Yes 8
2
Take out the spark plug, and make the electrode of
3
4
5
6
7
8
9
Yes Next
step
11
Clean the fuel injector and check the fuel injector for
fuel injection.
No
Replace fuel injector
Yes Replace
fuel
12
Check if the fuel is wrong or contains water.
No 18
Yes Next
step
13
Check if the fuel pressure is lower than 300kPa.
No 17
Yes Next
step
14
Close the fuel gauge valve. Turn on the ignition switch
again and keep the fuel pump working for 3 seconds.
Check if fuel pressure can be produced.
No 16
68
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст