Lifan 620. Manual — part 14
20. DTC: P0444, Canister Control Valve Driving Stage Control Circuit Voltage Too Low (see
Table 1-33)
Table 1-33
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to ON.
Next
step
2
3
4
5
6
57
21. DTC: P0445, Canister Control Valve Driving Stage Control Circuit Voltage Too High (see
Table 1-34)
Table 1-34
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to ON.
Next
step
Yes
Go to step 4
2
Disconnect the canister control valve from the harness.
Measure the voltage between the pin 1# of the control valve
3
4
5
6
1
2
Yes
harness
3
Check for open circuit or short to ground at the power supply
end of the A/C condenser cooling fan relay.
No
Go to step 2
Yes Replace
relay
4
Check the voltage between the pin 86# of the relay (control
end) and the power supply negative pole. Is the voltage
between 3.7V?
No Next
step
Yes
Repair or replace
harness
5
Check for open circuit or short to power supply or ground
between the pin 86# of relay control end and the pin 50# of
the ECU.
No Diagnosis
help
58
23. DTC: P0481, A/C Condenser Cooling Fan B Relay Control Circuit Trouble (see Table 1-36)
Table 1-36
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to OFF.
Next
step
Yes
Go to step 4
2
Disconnect A/C condenser cooling fan relay, and turn the
ignition switch to ON. Check the voltage between the pin
30#, 85# of the relay (power supply end) and the power
3
4
5
1
2
3
Yes Next
step
4
Check the vehicle speed sensor for normal operation.
No
Replace vehicle speed
sensor
Yes
Repair or replace
harness
5
Check for open circuit or short to power supply or ground
between the vehicle speed sensor signal line and the pin 59#
of the ECU.
No Diagnosis
help
59
25. DTC: P0506, Idle Speed Too Low (see Table 1-38)
Table 1-38
S/N Operation Test
Results
Actions
1
Connect the diagnostic instrument and adapter, and turn the
ignition switch to OFF.
Next
step
Yes Next
step
2
Check the throttle adjusting bolt, accelerator cable, throttle
3
4
1
2
3
Yes
Necessary check and
repair
4
A. Check the system for leakage;
B. Check the fuel injector for leakage;
C. Check if the pressure of the fuel supply system is too high.
No Diagnosis
help
60
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст