Infiniti M35/M45 Y50. Manual — part 82
ON-VEHICLE SERVICE
AT-251
D
E
F
G
H
I
J
K
L
M
A
B
AT
8.
Remove tightening bolts for rear extension assembly and trans-
mission case.
9.
Tap rear extension assembly with a soft hammer.
10. Remove rear extension assembly from transmission case. (With
needle bearing.)
11. Remove bearing race from output shaft.
12. Remove output shaft from transmission case by rotating left/
right.
SCIA6941E
SCIA3432E
SCIA3431E
SCIA5245E
SCIA5246E
AT-252
ON-VEHICLE SERVICE
13. Remove parking gear from output shaft.
14. Remove seal rings from output shaft.
15. Remove needle bearing (1) from rear extension.
16. Remove parking actuator support from rear extension.
17. Remove parking pawl (with return spring) and pawl shaft from
rear extension.
SCIA5247E
SCIA5209E
SCIA6179J
SCIA3423E
SCIA3424E
ON-VEHICLE SERVICE
AT-253
D
E
F
G
H
I
J
K
L
M
A
B
AT
18. Remove return spring (1) from parking pawl (2).
19. Remove rear oil seal from rear extension.
CAUTION:
Be careful not to scratch rear extension.
Inspection
●
If the contact surface on parking actuator support, parking pawl,
etc. has excessive wear, abrasion, bend, or any other damage,
replace the components.
SCIA6180J
SCIA3524E
SCIA5143E
SCIA5144E
AT-254
ON-VEHICLE SERVICE
Installation
CAUTION:
After completing installation, check A/T fluid leakage, A/T fluid level and A/T position. Refer to
,
AT-228, "Checking of A/T Position"
.
1.
As shown in the figure, use a drift to drive rear oil seal into the
rear extension until it is flush.
CAUTION:
●
Apply ATF to rear oil seal.
●
Do not reuse rear oil seal.
2.
Install return spring (1) to parking pawl (2).
3.
Install parking pawl (with return spring) and pawl shaft to rear
extension.
4.
Install parking actuator support to rear extension.
SCIA5311E
SCIA6180J
SCIA3424E
SCIA3423E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст