Infiniti FX35 / FX45. Manual — part 838
MA-32
< SERVICE INFORMATION >
CHASSIS AND BODY MAINTENANCE
Checking Brake Fluid Level and Leaks
INFOID:0000000001328928
• If fluid level is extremely low, check brake system for leaks.
Checking Brake Line and Cables
INFOID:0000000001328929
• Check brake fluid lines and parking brake cables for improper
attachment, leaks, chafing, abrasions, deterioration, etc.
Changing Brake Fluid
INFOID:0000000001328930
1.
Drain brake fluid from each bleed valve.
2.
Refill until new brake fluid comes out from each bleed valve.
Use same procedure as in bleeding hydraulic system to refill
brake fluid.
Refer to
.
• Refill with recommended Genuine NISSAN Super Heavy Duty
Brake Fluid or equivalent DOT 3 (US FMVSS No. 116).
Refer to
.
• Never reuse drained brake fluid.
• Be careful not to splash brake fluid on painted areas.
Checking Disc Brake
INFOID:0000000001328931
ROTOR
Check condition, wear, and damage.
CALIPER
• Check for leakage.
SBR451D
SBR389C
SBR419C
Front
Rear
Standard thickness
34.0 mm (1.339 in)
16.0 mm (0.630 in)
Runout limit (with the disc rotor attached
to the vehicle)
0.04 mm (0.0016 in)
0.05mm (0.0020 in)
Wear limit
32.0 mm (1.260 in)
14.0 mm (0.551 in)
CHASSIS AND BODY MAINTENANCE
MA-33
< SERVICE INFORMATION >
C
D
E
F
G
H
I
J
K
M
A
B
MA
N
O
P
PAD
• Check for wear or damage.
Checking Steering Gear and Linkage
INFOID:0000000001328932
STEERING GEAR
• Check gear housing and boots for looseness, damage and grease
leakage.
• Check connection with steering column for looseness.
STEERING LINKAGE
Check ball joint, dust cover and other component parts for looseness, wear, damage and grease leakage.
Checking Power Steering Fluid and Line
INFOID:0000000001328933
Check fluid level in reservoir tank with engine off.
Use “HOT” range at fluid temperatures of 50 to 80
°
C (122 to 176
°
F)
or “COLD” range at fluid temperatures of 0 to 30
°
C (32 to 86
°
F).
CAUTION:
• Do not overfill.
• Recommended fluid is Genuine NISSAN PSF or equivalent.
Refer to
SMA922A
Front
Rear
Standard thickness
11.0 mm (0.433 in)
8.5 mm (0.335 in)
Repair limit thickness
2.0 mm (0.079 in)
2.0 mm (0.079 in)
BRA0010D
SLIA0014E
SST850C
MA-34
< SERVICE INFORMATION >
CHASSIS AND BODY MAINTENANCE
• Check lines for improper attachment, leaks, cracks, damage,
loose connections, chafing and deterioration.
• Check rack boots for accumulation of power steering fluid.
Axle and Suspension Parts
INFOID:0000000001328934
Check front and rear axle and suspension parts for excessive play,
cracks, wear or other damage.
• Shake each wheel to check for excessive play.
• Check wheel bearings for smooth operation.
• Check axle and suspension nuts and bolts for looseness.
• Check strut (shock absorber) for oil leakage or other damage.
• Check suspension ball joint for grease leakage and ball joint dust
cover for cracks or other damage.
Drive Shaft
INFOID:0000000001328935
Check boot and drive shaft for cracks, wear, damage and grease
leakage.
SST851C
SMA525A
SFA392B
SFA108A
CHASSIS AND BODY MAINTENANCE
MA-35
< SERVICE INFORMATION >
C
D
E
F
G
H
I
J
K
M
A
B
MA
N
O
P
Lubricating Locks, Hinges and Hood Latch
INFOID:0000000001328936
Checking Seat Belt, Buckles, Retractors, Anchors and Adjusters
INFOID:0000000001328937
CAUTION:
• After any collision, inspect all seat belt assemblies, including retractors and other attached hard-
wares (I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt assemblies in use
during a collision, unless not damaged and properly operating after minor collision.
Also inspect seat belt assemblies not in use during a collision, and replace if damaged or improperly
operating.
Seat belt pre-tensioner should be replaced even if the seat belts are not in use during a frontal colli-
sion where the driver and passenger air bags are deployed.
• If any component of seat belt assembly is questionable, do not repair.
Replace as seat belt assembly.
• If webbing is cut, frayed, or damaged, replace belt assembly.
• Never oil tongue and buckle.
• Use a genuine NISSAN seat belt assembly.
PIIA7009E
PIIB7160E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст