Infiniti FX35 / FX45. Manual — part 616
EI-28
< SERVICE INFORMATION >
DOOR PARTING SEAL
3.
Install rear door parting seal to rear door hem flange.
4.
Install rear door outside lower molding. Refer to
EI-26, "Removal and Installation"
CAUTION:
Rear door parting seal is not reusable. always use new rear door parting seal.
CENTER MUD GUARD
EI-29
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
M
A
B
EI
N
O
P
CENTER MUD GUARD
Component Parts Location
INFOID:0000000001328068
Removal and Installation
INFOID:0000000001529403
REMOVAL
1.
Remove bolts center mud-guard lower portion.
2.
Remove screws center mud-guard front and rear portion.
3.
Insert driver rolled with cloth or tapes between guard and body side sill, then pull it back to your side.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing center mud guard, make sure that clips are securely fitted in panel holes on body, and
then press them in.
1.
Center mud-guard
2.
Grommet
3.
Clip
4.
Bolt
5.
Screw
PIIA4328E
EI-30
< SERVICE INFORMATION >
WINDSHIELD MOLDING
WINDSHIELD MOLDING
Component Parts Location
INFOID:0000000001328069
Removal and Installation
INFOID:0000000001529404
REMOVAL
Remove windshield molding. Refer to
GW-11, "Removal and Installation"
.
INSTALLATION
Install windshield molding. Refer to
GW-11, "Removal and Installation"
1.
Dam rubber
2.
Molding
3.
Windshield glass
4.
Spacer
5.
Mirror base
6.
Bond
7.
Insulator
8.
Panel
9.
Body side (outer)
10. Cowl top cover
11. Pad
12.
Bracket
PIIA9190E
BACK DOOR WINDOW MOLDING
EI-31
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
M
A
B
EI
N
O
P
BACK DOOR WINDOW MOLDING
Component Parts Location
INFOID:0000000001328070
Removal and Installation
INFOID:0000000001529405
REMOVAL
Remove back door window molding. Refer to
GW-13, "Removal and Installation"
NOTE:
Apply a strip of protective tape along the contour of back door window glass (molding) to prevent paint surface
from being damaged.
INSTALLATION
Install back door window molding. Refer to
GW-13, "Removal and Installation"
.
NOTE:
• Clean adhesive portion of back door window glass and around circumference with white gasoline.
• Apply dam rubber to upper and side surfaces of glass.
• Attach back door window molding to side face of glass.
• Back door window molding should not overlap on the surface of back door window glass.
1.
Dam rubber
2.
Back door window glass
3.
Bond
4.
Back door outer panel
5.
Back door inner panel
6.
Back door window molding
7.
Clip
8.
Back door panel
PIIA9191E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст