Infiniti M45 (Y34). Manual — part 219
REMOTE KEYLESS ENTRY SYSTEM
BL-101
C
D
E
F
G
H
J
K
L
M
A
B
BL
5.
Touch “IVMS”.
If “IVMS” is not indicated, go to
.
6.
Check the model specification, touch either “WITH SUNROOF”
or “WITHOUT SUNROOF”.
7.
Touch “OK”. If the selection is wrong, touch “CANCEL”.
8.
Touch “MULTI-REMOTE CONT SYS”.
9.
Touch “WORK SUPPORT”.
10. The item shown on the figure at right can be set up.
●
“REMO CONT ID CONFIR”
Use this mode to confirm if a electronic key ID code is registered
or not.
●
“REMO CONT ID REG”
Use this mode to register a electronic key ID code.
NOTE:
Register the ID code when electronic key or BCM is replaced, or
when additional electronic key is required.
●
“REMO CONT ID ERASUR”
Use this mode to erase a electronic key ID code.
PIIA0183E
PIIA0184E
PIIA0373E
SEL274W
BL-102
REMOTE KEYLESS ENTRY SYSTEM
Removal and Installation of Remote Keyless Entry Receiver
AIS001Q7
REMOVAL
1.
Remove the rear pillar finisher upper (LH). Refer to
2.
Disconnect the remote keyless entry receiver connector, mount-
ing screw and remove the remote keyless entry receiver.
INSTALLATION
Install in the reverse order of removal.
PIIA3440E
DOOR
BL-103
C
D
E
F
G
H
J
K
L
M
A
B
BL
DOOR
PFP:80100
Fitting Adjustment
AIS001E9
FRONT DOOR
Longitudinal Clearance and Surface Height Adjustment at Front End
1.
Accessing from inside the fender, loosen the hinge mounting bolts. Raise the front door at rear end to
adjust.
REAR DOOR
Longitudinal Clearance and Surface Height Adjustment at Front End
1.
Remove the center pillar upper garnish and center pillar lower garnish. Refer to
.
2.
Accessing from inside the vehicle, loosen the mounting bolts and nuts. Open the rear door, and raise the
rear door at rear end to adjust.
STRIKER ADJUSTMENT
1.
Remove the striker cover.
PIIA3061E
SIIA0886E
BL-104
DOOR
2.
Adjust the striker so that it becomes parallel with the lock inser-
tion direction.
Removal and Installation of Front Door
AIS001EA
REMOVAL
CAUTION:
●
When removing and installing the front door assembly, support the door with a jack and cloth to
protect the door and body.
●
When removing and installing front door assembly, be sure to carry out the fitting adjustment
Refer to
●
Operate with two workers, because of its heavy weight.
●
Check the hinge rotating part for poor lubrication. If necessary, apply “body grease”.
●
After installing, check operation.
1.
Pull the lever and remove the front door harness connector
while removing tabs of door harness connector.
2.
Remove the mounting bolts of the check link on the vehicle.
3.
Remove the door-side hinge mounting nuts, and remove the
door assembly.
SIIA0338E
PIIA2514E
PIIA2515E
PIIA3057E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст