Infiniti FX35, FX50 (S51). Manual — part 1084
FAX-34
< REMOVAL AND INSTALLATION >
[AWD]
FRONT DRIVE SHAFT
a.
For one-touch clamp band. (Left side)
i.
Install boot bands securely as shown in the figure.
b.
For low profile type band. (Right side)
i.
Put boot band in the groove on drive shaft boot. Then fit pawls
(
) into holes to temporary installation.
NOTE:
For the large diameter side, fit projection (A) and guide slit (B) at
first.
ii.
Pinch projection on the band with suitable pliers to tighten band.
iii.
Insert tip of band below end of the pawl.
14. Secure housing and shaft, and then make sure that they are in
the correct position when rotating boot. Install them with boot
band when the mounting positions become incorrect.
15. Install dust shield to housing. (right side)
CAUTION:
Never reuse dust cover.
Inspection
INFOID:0000000005248999
INSPECTION AFTER REMOVAL
• Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for signifi-
cant looseness.
• Check boot for cracks, damage, and leakage of grease.
• Disassemble drive shaft and exchange malfunctioning part if there
is a non-standard condition.
INSPECTION AFTER DISASSEMBLY
Shaft
Check shaft for runout, cracks, or other damage. Replace it if necessary.
Joint Sub-Assembly (Wheel Side)
PDIA1188J
SDIA3557E
SDIA3558E
SDIA1163J
FRONT DRIVE SHAFT
FAX-35
< REMOVAL AND INSTALLATION >
[AWD]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
Check the following items, replace the parts if necessary.
• Joint sub-assembly for rough rotation and excessive axial looseness.
• The inside of the joint sub-assembly for entry of foreign material.
• Joint sub-assembly for compression scars, cracks, and fractures inside of joint sub-assembly.
Replace joint sub-assembly if there are any non-standard conditions of components.
Housing and Spider assembly (Final Drive side)
Replace housing and spider assembly if there is scratching or wear of housing roller contact surface or spider
roller contact surface.
NOTE:
Housing and spider assembly are used in a set.
FAX-36
< SERVICE DATA AND SPECIFICATIONS (SDS)
[AWD]
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Bearing
INFOID:0000000005249000
Drive Shaft
INFOID:0000000005249001
VQ35HR
VK50VE
Item Standard
Axial end play
0.05 mm (0.002 in) or less
Item
Left side
Right side
Grease quantity
Wheel side
77 – 97 g (2.72 – 3.42 oz)
Final drive side
95 – 105 g (3.36 – 3.70 oz)
113 – 123 g (3.99 – 4.33 oz)
Boots installed
length
Wheel side
136 mm (5.35 in)
Final drive side
152 mm (5.98 in)
158.6 mm (6.24 in)
Item
Left side
Right side
Grease quantity
Wheel side
77 – 97 g (2.72 – 3.42 oz)
Final drive side
95 – 105 g (3.36 – 3.70 oz)
113 – 123 g (3.99 – 4.33 oz)
Boots installed
length
Wheel side
136 mm (5.35 in)
Final drive side
149.5 mm (5.89 in)
158.6 mm (6.24 in)
FL-1
ENGINE
C
D
E
F
G
H
I
J
K
L
M
SECTION
FL
A
FL
N
O
P
CONTENTS
FUEL SYSTEM
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
General Precautions . . . . . . . . . . . .....
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Commercial Service Tools . . . . . . . . . ....
PERIODIC MAINTENANCE . . . . . . ..
FUEL SYSTEM . . . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . . ..
Quick Connector . . . . . . . . . . . . . ...
REMOVAL AND INSTALLATION . . . .
FUEL LEVEL SENSOR UNIT, FUEL FILTER
AND FUEL PUMP ASSEMBLY . . . . . . ..
Exploded View . . . . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . ...
Inspection . . . . . . . . . . . . . . . . .
FUEL TANK . . . . . . . . . . . . . ..
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
UNIT DISASSEMBLY AND ASSEMBLY .
FUEL LEVEL SENSOR UNIT, FUEL FILTER
AND FUEL PUMP ASSEMBLY . . . . . .
Exploded View . . . . . . . . . . . . . . .
Disassembly . . . . . . . . . . . . . . .
Assembly . . . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст