Infiniti FX35, FX50 (S51). Manual — part 1075
EXT-50
< REMOVAL AND INSTALLATION >
BACK DOOR FINISHER
3.
Remove back door finisher upper fixing nuts (A).
4.
Disconnect back door request switch harness connector (B).
5.
Pull harness grommet (C) outwards from back door to release.
6.
Remove back door finisher upper (1) fixing clips with remover
tool (A).
CAUTION:
• Apply protective tape (B) on the back door panel to pro-
tect the painted surface from damage.
• Never use an item as a remover tool that could damage
back door panel.
• Disengage the clips slowly and carefully.
• Never pull the back door finisher upper strongly.
7.
Pull back door finisher upper to remove.
8.
Remove door handle cover (1) fixing clips (A).
9.
Remove door handle cover fixing pawls, and then remove door
handle cover.
BACK DOOR FINISHER LOWER
1.
With a remover tool (A) and cutter knife (B), take off double-
faced adhesive tape, and then disengage back door finisher
lower (1) fixing pawls.
CAUTION:
• Apply protective tape (C) on the back door panel to pro-
tect the painted surface from damage.
• Never use an item as a remover tool that could damage
back door panel.
• Disengage the pawls slowly and carefully.
• Never pull the back door finisher lower strongly.
2.
Pull and remove back door finisher lower.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Remove double-faced adhesive tape remaining on back door with a double-faced adhesive tape
remover, after removing back door finisher lower.
• Never wash the vehicle within 24 hours after installing so as to keep adhesive.
JMKIA2772ZZ
: Clip
JMKIA2218ZZ
: Pawl
JMKIA2763ZZ
: Pawl
JMKIA2764ZZ
BACK PILLAR FINISHER
EXT-51
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
BACK PILLAR FINISHER
Exploded View
INFOID:0000000005248889
Removal and Installation
INFOID:0000000005248890
REMOVAL
1.
Disengage back door stay upper from back door stay bracket. Refer to
.
2.
Remove back pillar finisher cover (1) with flat-bladed screwdriver (A).
1.
Back door stay
2.
Back pillar finisher
3.
Back door stay bracket
4.
Double-faced adhesive tape
: Clip
Refer to
JMKIA2765ZZ
: Pawl
JMKIA2766ZZ
EXT-52
< REMOVAL AND INSTALLATION >
BACK PILLAR FINISHER
3.
Remove back pillar finisher (1) fixing clip with a remover tool (A).
CAUTION:
Never use an item as a remover tool that could damage
body panel.
4.
Remove back pillar finisher (1) fixing double-faced adhesive
tape (A) and clip with a remover tool (B).
CAUTION:
Never use an item as a remover tool that could damage
body panel.
5.
Remove back pillar finisher.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Replace double-faced adhesive tape with a new one, if the back pillar finisher is reused.
• Remove double-faced adhesive tape remaining on body panel and back of back pillar finisher with a
double-faced adhesive tape remover, after removing back pillar finisher.
• When installing, visually check the back pillar finisher and the clips, then replace them with new
parts, if they are damaged.
• Never wash the vehicle within 24 hours after installing so as to keep adhesive.
: Clip
JMKIA2768ZZ
: Clip
JMKIA2769ZZ
FAX-1
TRANSMISSION & DRIVELINE
C
E
F
G
H
I
J
K
L
M
SECTION
FAX
A
B
FAX
N
O
P
CONTENTS
FRONT AXLE
2WD
SYMPTOM DIAGNOSIS . . . . . . . ...
NOISE, VIBRATION AND HARSHNESS
(NVH) TROUBLESHOOTING . . . . . . . .
NVH Troubleshooting Chart . . . . . . . . . ..
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Commercial Service Tool . . . . . . . . . . ..
PERIODIC MAINTENANCE . . . . . . ..
FRONT WHEEL HUB AND KNUCKLE . . . ..
Inspection . . . . . . . . . . . . . . . . ..
REMOVAL AND INSTALLATION . . . .
FRONT WHEEL HUB AND KNUCKLE . . . ..
Exploded View . . . . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . ...
Inspection . . . . . . . . . . . . . . . . ..
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . . . ...
Wheel Bearing . . . . . . . . . . . . . . ...
AWD
SYMPTOM DIAGNOSIS . . . . . . . ...
NOISE, VIBRATION AND HARSHNESS
(NVH) TROUBLESHOOTING . . . . . . . .
NVH Troubleshooting Chart . . . . . . . . . ..
PRECAUTION . . . . . . . . . . . ..
PRECAUTIONS . . . . . . . . . . . . ..
Precaution Necessary for Steering Wheel Rota-
tion after Battery Disconnect . . . . . . . . ...
Precautions for Drive Shaft . . . . . . . . . ..
PREPARATION . . . . . . . . . . ...
PREPARATION . . . . . . . . . . . . .
Special Service Tool . . . . . . . . . . . .
Commercial Service Tool . . . . . . . . . .
PERIODIC MAINTENANCE . . . . . .
FRONT WHEEL HUB AND KNUCKLE . . .
Inspection . . . . . . . . . . . . . . . .
FRONT DRIVE SHAFT . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . ...
FRONT WHEEL HUB AND KNUCKLE . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
FRONT DRIVE SHAFT BOOT . . . . . . ..
Exploded View . . . . . . . . . . . . . . .
WHEEL SIDE . . . . . . . . . . . . . . . .
WHEEL SIDE : Removal and Installation . . . .
FINAL DRIVE SIDE . . . . . . . . . . . . .
FINAL DRIVE SIDE : Removal and Installation . ...
Inspection . . . . . . . . . . . . . . . .
FRONT DRIVE SHAFT . . . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
LEFT SIDE . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст