Infiniti FX35, FX50 (S51). Manual — part 1754
ST-8
< PRECAUTION >
PRECAUTIONS
Service Notice or Precautions for Steering System
INFOID:0000000005235266
• In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle
condition, and then check wheel alignment.
• Observe the following precautions when disassembling.
- Before disassembly, thoroughly clean the outside of the unit.
- Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming
contaminated by dirt or other foreign matter.
- For easier and proper assembly, place disassembled parts in order on a parts rack.
- Use nylon cloth or paper towels to clean the parts; common shop rags can leave lint that might interfere with
their operation.
- Never reuse non-reusable parts.
- Before assembling, apply the specified grease to the directed parts.
PREPARATION
ST-9
< PREPARATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000005235267
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Tool number
(Kent-Moore No.)
Tool name
Description
ST27180001
(J-25726-A)
Steering wheel puller
Removing steering wheel
ST3127S000
(J-25765-A)
Preload gauge
Inspecting sliding torque, steering torque, and
rotating torque for ball joint
KV48104400
(
—
)
Teflon ring correcting tool
a: 50 mm (1.97 in) dia.
b: 36 mm (1.42 in) dia.
c: 100 mm (3.94 in)
Installing rack Teflon ring
KV48103400
(
—
)
Preload adapter
Inspecting rotating torque
ST35300000
(
—
)
Drift
a: 45.1 mm (1.776 in) dia.
b: 59.0 mm (2.323 in) dia.
Installing oil pump oil seal
ZZA0819D
ZZA0806D
S-NT550
ZZA0824D
ZZA0881D
ST-10
< PREPARATION >
PREPARATION
Commercial Service Tools
INFOID:0000000005588767
KV48103500
(J-26357)
Oil pressure gauge
Measuring oil pump relief pressure
KV48102500
(J-33914)
Oil pressure gauge adapter
Measuring oil pump relief pressure
Tool number
(Kent-Moore No.)
Tool name
Description
S-NT547
S-NT542
Tool name
Description
Power tool
Loosening bolts and nuts
Ball joint remover
Remove steering outer socket
Open head
Tighten end cover assembly
PBIC0190E
S-NT146
ZZA0822D
PREPARATION
ST-11
< PREPARATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
Drift
a: 15 mm (0.59 in) dia.
b: 10 mm (0.39 in) dia.
Installing rotor snap ring
Drift
a: 36 mm (1.42 in) dia.
b: 20 mm (0.79 in) dia.
Installing oil pump oil seal (VK50VE models)
Tool name
Description
S-NT474
S-NT474
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст