Infiniti F50. Manual — part 521
DRIP MOLDING
EI-25
C
D
E
F
G
H
J
K
L
M
A
B
EI
DRIP MOLDING
PFP:76810
Removal and Installation
EIS000DE
REMOVAL
1.
Lift molding in order from front edge with resin spatula or equivalent. Hold connections of clips, lift molding
vertically to installation part, and disconnect clip C.
2.
Place down rear edge of drip molding to your side. Break clip on molding side, then disconnect clip A.
INSTALLATION
1.
Insert bolt of clip B. Hold stopper part to avoid coming over clip C, and connect clip A.
2.
Connect clip C in order from rear side.
PIIA0041E
EI-26
ROOF SIDE MOLDING
ROOF SIDE MOLDING
PFP:73854
Removal and Installation
EIS000DF
REMOVAL
Lift and twist roof side molding up from rear edge. Disengage clips, and remove roof side molding.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install roof side molding, always insert its front edge part inside of windshield molding.
PIIA0040E
DOOR OUTSIDE MOLDING
EI-27
C
D
E
F
G
H
J
K
L
M
A
B
EI
DOOR OUTSIDE MOLDING
PFP:82820
Removal and Installation
EIS000DG
FRONT DOOR OUTSIDE MOLDING
Removal
1.
Open windows fully.
2.
Lift up rear edge, push down center tip of clip, and pull out molding.
3.
Lift and twist from rear side, disengage clips from flange, and pull out molding to backward.
Installation
Install in the reverse order of removal.
REAR DOOR OUTSIDE MOLDING
Removal
1.
Open windows fully.
2.
Remove screws on rear edge.
3.
Lift and twist from rear side, and disengage clips from flange.
4.
Push down center tip of clip B, pull out and remove molding.
Installation
Install in the reverse order of removal.
PIIA0042E
EI-28
SIDE GUARD MOLDING
SIDE GUARD MOLDING
PFP:76840
Removal and Installation
EIS000DH
REMOVAL
1.
Apply masking tape around outer circumference of side guard molding.
2.
Remove double-faced adhesive tapes with (wide) resin spatula. Disengage clips and remove side guard
molding.
INSTALLATION
1.
Remove double-faced adhesive tape remaining on vehicle.
2.
Clean contact surface of vehicle (to side guard molding), and install side guard molding to vehicle.
NOTE:
To re-use side guard molding, follow above steps 1 and 2 as well; clean surface after removing double-
faced adhesive tape, apply new double-faced adhesive tape as shown in illustration, then install side
guard molding to vehicle.
CAUTION:
●
Do not let air between contact surfaces when installing.
●
To secure contact, do not wash vehicle within 24 hours after installation.
PIIA0043E
Double–faced adhesive tape
thickness: 6 mm (0.24 in) (upper
side)
thickness: 8 mm (0.31 in) (lower
side)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст