Infiniti F50. Manual — part 520
FENDER PROTECTOR
EI-21
C
D
E
F
G
H
J
K
L
M
A
B
EI
FENDER PROTECTOR
PFP:63840
Removal and Installation
EIS000DA
REMOVAL
1.
Remove bolts and clips of fender protector.
2.
Remove fender protector (front/rear).
INSTALLATION
Install in the reverse order of removal.
PIIA0038E
EI-22
MUDGUARD
MUDGUARD
PFP:63854
Removal and Installation
EIS0013L
REMOVAL
1.
Remove mudguard finisher. Refer to
EI-37, "Removal and Installation"
2.
Remove screws on front and lower side of center mudguard.
3.
Remove clips on front and rear end of center mudguard.
4.
Remove center mudguard.
INSTALLATION
Install in the reverse order of removal.
PIIA0039E
WINDSHIELD MOLDING
EI-23
C
D
E
F
G
H
J
K
L
M
A
B
EI
WINDSHIELD MOLDING
PFP:72700
Removal and Installation
EIS0013M
REMOVAL
1.
Apply protective tape around outer circumference of windshield molding.
2.
Remove clips in order of a and b. Pull upper part to outer side of vehicle.
INSTALLATION
1.
Cut double-faced adhesive tape of fastener with cutter knife.
Remove fastener (upper).
2.
Remove any excess glue on windshield or flange with cutter
knife.
3.
Remove remains of double-faced adhesive tape on flange with remover.
CAUTION:
Do not handle remover around fire or flame, or in closed areas.
4.
Fix double-faced adhesive tape on new fastener on flange from
center of vehicle to outer side with spatula.
PIIA0138E
1.
Fastener (upper)
2.
Clip
3.
Rivet
4.
Fastener (lower)
5.
Windshield molding
6.
Joint
SIIA1006E
PIIA0139E
EI-24
WINDSHIELD MOLDING
5.
Connect clips in order of a and b.
6.
Connect joint 6, then clips in order of b and c.
PIIA0140J
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст