Infiniti F50. Manual — part 522
LICENSE LAMP FINISHER
EI-29
C
D
E
F
G
H
J
K
L
M
A
B
EI
LICENSE LAMP FINISHER
PFP:84810
Removal and Installation
EIS0013P
REMOVAL
1.
Remove trunk lid finisher. Refer to
EI-52, "Removal and Installation"
.
2.
Remove nuts and clips on trunk lid of license lamp finisher.
INSTALLATION
Install in the reverse order of removal.
PIIA0044E
EI-30
DOOR FINISHER
DOOR FINISHER
PFP:80900
Removal and Installation
EIS000DJ
SIIA0805E
1.
Front door sash cover
2.
Inside handle escutcheon (front)
3.
Front door finisher
4.
Front armrest finisher
5.
Front door upper finisher
6.
Rear door sash cover
7.
Hook
8.
Rear side sunshade
9.
Inside handle escutcheon (rear)
10.
Rear door finisher
11.
Rear armrest finisher
12.
Rear door lower finisher
13.
Bumper rubber
14.
Step lamp
DOOR FINISHER
EI-31
C
D
E
F
G
H
J
K
L
M
A
B
EI
FRONT DOOR FINISHER
Removal
1.
Insert screw driver rolled with cloth or tapes into dip at rear of
inside handle escutcheon, and pull it back to your side. Discon-
nect upper pawl, lower and front, and remove inside handle
escutcheon.
2.
Insert clip screw driver rolled with cloth into dip under arm-rest
finisher, and lift up finisher. Insert your fingers between gaps,
pull it back to your side and disconnect metal clips.
3.
Disconnect trunk lid opener and fuel lid opener switch connec-
tor.
4.
Insert screw driver rolled with cloth under front part of front door
upper finisher, pull it back to your side and remove it.
5.
Disconnect power window switch connector under arm-rest.
6.
Remove step lamp, and disconnect connectors.
7.
Remove nine screws of door finisher.
8.
Insert screw driver rolled with cloth into clips under door finisher, and disconnect clips.
9.
Pull up door finisher, and remove connectors, inside handle
cable and lock knob cable.
SIIA0806E
SIIA0807E
SIIA0808E
SIIA0266E
EI-32
DOOR FINISHER
NOTE:
Insert screw driver rolled with cloth between panel on vehicle
and clips (as indicated with arrow), and remove finisher.
Installation
Install in the reverse order of removal.
CAUTION:
To install finisher, check if all clips are matched over holes of panel on vehicle, then push in.
REAR DOOR FINISHER
Removal
1.
Insert screw driver rolled with cloth or tape into dip at rear of
inside handle escutcheon, and pull it back to your side.Disen-
gage upper pawls, lower and front, and remove inside handle
escutcheon.
2.
Insert screw driver rolled with cloth into dip under arm-rest fin-
isher, and lift up finisher. Insert your fingers between gaps, pull it
back to your side, and disconnect metal clips.
3.
Insert screw driver rolled with cloth under rear door lower fin-
isher, and pull it back to your side. Remove rear door lower fin-
isher and disconnect connectors.
4.
Disconnect power window switch connector under arm-rest.
5.
Remove step lamp, and disconnect connectors.
6.
Remove seven screws of door finisher.
SIIA0810E
SIIA0806E
SIIA0807E
SIIA0809E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст