Infiniti G35 (V35). Manual — part 62
ON-VEHICLE SERVICE
AT-239
D
E
F
G
H
I
J
K
L
M
A
B
AT
15. Remove needle bearing (1) from rear extension.
16. Remove parking actuator support from rear extension.
17. Remove parking pawl (with return spring) and pawl shaft from
rear extension.
18. Remove return spring (1) from parking pawl (2).
19. Remove rear oil seal from rear extension.
CAUTION:
Be careful not to scratch rear extension.
SCIA6179J
SCIA3423E
SCIA3424E
SCIA6180J
SCIA3524E
AT-240
ON-VEHICLE SERVICE
INSPECTION
●
If the contact surface on parking actuator support, parking pawl,
etc. has excessive wear, abrasion, bend, or any other damage,
replace the components.
INSTALLATION
CAUTION:
After completing installation, check A/T position, A/T fluid leakage and A/T fluid level. Refer to
.
1.
As shown in the figure, use a drift to drive rear oil seal into the
rear extension until it is flush.
CAUTION:
●
Do not reuse rear oil seal.
●
Apply ATF to rear oil seal.
2.
Install return spring (1) to parking pawl (2).
SCIA5143E
SCIA5144E
SCIA5311E
SCIA6180J
ON-VEHICLE SERVICE
AT-241
D
E
F
G
H
I
J
K
L
M
A
B
AT
3.
Install parking pawl (with return spring) and pawl shaft to rear
extension.
4.
Install parking actuator support to rear extension.
5.
Install needle bearing (1) to rear extension.
CAUTION:
●
Take care with direction of needle bearing. Refer to
262, "Locations of Adjusting Shims, Needle Bearings,
Thrust Washers and Snap Rings"
●
Apply petroleum jelly to needle bearing (1).
Refer to GI section to make sure icons (symbol marks) in the fig-
ure. Refer to
6.
Install seal rings to output shaft.
CAUTION:
●
Do not reuse seal rings.
●
Apply petroleum jelly to seal rings.
7.
Install parking gear to output shaft.
SCIA3424E
SCIA3423E
SCIA6179J
SCIA5209E
SCIA5247E
AT-242
ON-VEHICLE SERVICE
8.
Install output shaft in transmission case.
9.
Install bearing race to output shaft.
10. Apply recommended sealant (Genuine Anaerobic Liquid Gasket
GI-46, "Recommended Chemical Prod-
.) to rear extension assembly as shown in
the figure.
CAUTION:
Completely remove all moisture, oil and old sealant, etc.
from the transmission case and rear extension assembly
mounting surfaces.
11. Install rear extension assembly to transmission case. (With nee-
dle bearing.)
CAUTION:
Insert the tip of parking rod between the parking pawl and
the parking actuator support when assembling the rear
extension assembly.
12. Tighten rear extension assembly mounting bolts to specified
torque. Refer to
.
CAUTION:
Do not reuse self-sealing bolts.
SCIA5246E
SCIA5245E
SCIA8228E
SCIA3431E
SCIA6941E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст