Infiniti G35 (V35). Manual — part 195
TRUNK LID
BL-167
C
D
E
F
G
H
J
K
L
M
A
B
BL
INSTALLATION
1.
Install in the reverse order of removal.
2.
After installing, check the operation.
Removal and Installation of Trunk Lid Lock
NIS000CG
REMOVAL
1.
Remove the trunk lid finisher. Refer to
Installation for Trunk Room Trim"
2.
Disconnect the emergency handle and trunk lid opener cable
from the clip.
3.
After removing the harness connector, remove the mounting
bolts, and remove the trunk lid lock.
INSTALLATION
1.
Install in the reverse order of removal.
2.
After installing, close the trunk lid height. Perform the lock and surface height adjustment. Refer to
3.
After installing, check the operation.
Removal and Installation of Trunk Lid Striker
NIS000CH
REMOVAL
1.
Remove the trunk rear plate and trunk rear finisher. Refer to
38, "Removal and Installation for Trunk Room Trim"
2.
Remove the mounting bolts, and remove the striker from the
trunk lock support.
INSTALLATION
1.
Install in the reverse order of removal.
2.
After installing, close the trunk lid height. Perform the lock and surface height adjustment. Refer to
3.
After installing, check the operation.
PIIB9130E
PIIA0641E
BL-168
TRUNK LID
Removal and Installation of Trunk lid Emergency Opener Cable
NIS000CI
REMOVAL
1.
Remove trunk lid finisher. Refer to
EI-38, "TRUNK ROOM TRIM & TRUNK LID FINISHER"
.
2.
Disconnect each clamp of trunk lid emergency opener cable.
3.
Disconnect the trunk lid emergency opener cable and from the trunk lid lock assembly.
4.
Disconnect the trunk lid emergency opener cable from the trunk lid emergency opener lever holder.
5.
Remove trunk lid emergency opener cable.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
After installing, check the operation.
Removal and Installation of Trunk Lid Weatherstrip
NIS000CJ
1.
Trunk rid lock assembly
2.
Trunk rid emergency opener cable
3.
Trunk rid emergency opener lever
holder
4.
Trunk rid emergency opener lever
PIIB9131E
PIIA0642E
TRUNK LID
BL-169
C
D
E
F
G
H
J
K
L
M
A
B
BL
REMOVAL
Pull up and remove engagement with body from weatherstrip joint.
CAUTION:
After removal, do not pull strongly on the weatherstrip.
INSTALLATION
1.
Working from the upper section, align weatherstrip mark with vehicle center position mark and install
weatherstrip onto the vehicle.
2.
For the lower section, align the weatherstrip seam with center of the striker.
3.
After installation, pull the weatherstrip gently to ensure that there is no loose section.
NOTE:
Make sure the weatherstrip is fit tightly at each corner and back door rear plate.
BL-170
TRUNK LID OPENER
TRUNK LID OPENER
PFP:84640
Component Parts and Harness Connector Location
NIS001J8
System Description
NIS001J9
Power is supplied at all times
●
through 50A fusible link (letter F, located in the fuse and fusible link box)
●
to BCM terminal 55,
●
through 10A fuse [No.18, located in the fuse block (J/B)]
●
to BCM terminal 42.
Ground is supplied
●
to BCM terminal 52
●
through body grounds M30 and M66.
When trunk lid opener cancel switch is ON and trunk lid opener switch is ON (pushed)
PIIB9156E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст