Volkswagen Golf / Golf GTI / Jetta. Manual — part 751
69 - 5
Crash sensors
Crash sensor for driver-side and passenger
side - side airbag, assembly overview
1. Driver-side and passenger-side
sensor
¡
Removing
69-5, Crash
sensor for driver
side/passenger side curtain
protection, removing and
installing
2. Connector
3. Bolt
¡
Qty. 2, 6 Nm
Crash sensors
13/2/2005
4. Carpet
Crash sensor for driver side/passenger side
curtain protection, removing and installing
Note:
n
Removal and installation is described for left side of
vehicle. same instructions apply for removal and
installation for right-hand side.
n
Observe notes regarding coding in radio operators
manual before disconnecting battery.
n
After connecting battery, vehicle options (radio, clock,
electric window regulator) must be checked according
to repair manual and/or user manual.
Removing
- Switch ignition off.
- Disconnect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
- Remove driver /passenger seat
72-1, Front seats,
removing and installing
.
Caution!
Observe safety precautions for working on airbags
69-4, Safety precautions when working on airbags
.
- Remove floor carpet - 4 - and insulation
mat in sensor area.
Caution!
Electrostatic charges may result in
involuntary deployment of airbag.
Therefore, mechanic must be
electrostatically discharged before
disconnecting ignition- and Ground
(GND) wires. This is done e.g. by
briefly grasping chassis or door
striker.
Crash sensors
13/2/2005
- Disconnect harness connector - 2 - and
unscrew two bolts - 3 - (6 Nm).
Installing
- Installation is reverse of removal.
- Switch on ignition.
- Close doors.
Caution!
Make sure no one is in vehicle.
- Connect battery Ground (GND) strap
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
Crash sensors
13/2/2005
.
Crash sensor for driver side/Passengers
side rear side curtain protection, removing
and installing
Note:
n
Removal and installation is described for right side of
vehicle. same instructions apply for removal and
installation for left-hand side.
n
illustration shows chassis version of notchback,
removal of crash sensor side rear level airbag is
identical for sedan and wagon.
n
Observe notes regarding coding in radio operators
manual before disconnecting battery.
n
After connecting battery, vehicle options (radio, clock,
electric window regulator) must be checked according
to repair manual and/or user manual.
n
"crash sensor for rear side-airbag" sends signal to
deploy head-level and side-airbags in certain accident
situations.
n
"crash sensor for rear side-airbag on
driver /Passengers side" is listed as a replacement
part under "control module for side curtain
protection" .
Removing
- Switch ignition off.
- Disconnect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
- Remove wheel housing trim.
n
Golf
70-3, Wheel housing trim, removing and
installing (Golf)
.
n
Jetta
70-3, Wheel housing trim, removing and
installing (Jetta)
.
Crash sensors
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст