Volkswagen Golf / Golf GTI / Jetta. Manual — part 142
01-147
Must appear on display when all
diagnosis functions have been
successfully completed:
Readiness code
00000000 - Test complete
Indicated on display:
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
Readiness code
00101101 - Test not complete
Appears on display:
One of the diagnostic checks has not
run through successfully:
- Press
button.
- Generate readiness code
Page
01-149
.
Readiness code
01-148
Significance of figures in 8 digit number block, display zone 1 - Readiness code
The readiness code is generated only when all display zones show 0
1 2 3 4 5 6 7 8
Diagnostic function
0 Three Way Catalytic Converter (TWC)
0 Three Way Catalytic Converter (TWC) heating (currently no
diagnosis/always "0")
0
Evaporative Emissions (EVAP) Canister system (Tank
ventilation system)
0
Secondary air system
0
Air conditioner (currently no diagnosis/always "0")
0
Oxygen Sensor (O2S)s
0
Oxygen Sensor (O2S) heating
0
Exhaust gas recirculation (not installed/always "0")
Readiness code
01-149
Generating readiness code
Special tools, workshop
equipment, testers, measuring
instruments and auxiliary items
required
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the
vehicle diagnostic, testing and
information system VAS 5051.
Test prerequisites
VAG 1551 scan tool (or VAG
1552) with VAG 1551/3 Adapter
cable
All fuses must be OK.
Readiness code
01-150
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
The main fuses must be OK.
The battery voltage must be at
least 11.5 V.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Exhaust system between Three
Way Catalytic Converter (TWC)
and cylinder head must be free
of leaks
Ignition switched on, engine not
running.
Fuel Pump (FP) relay -J17- must
be OK., checking:
The signal from Brake Light
Switch -F- and Brake Vacuum
Vent Valve Switch -F47- -F85-
must be OK., checking
Page
24-206
.
Engine Coolant Temperature
(ECT) must be 85...110 C
display group 4, display zone
3.
Intake Air Temperature (IAT)
less than 80 C display group
4, display zone 4.
Three Way Catalytic Converter
(TWC) temperature must be at
least 380 C
display group
34, display zone 2.
Readiness code
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст