Volkswagen Golf / Golf GTI / Jetta. Manual — part 141
01-143
If one of the fuel injectors is not activated (does
not click):
- Press -C- button to abort output Diagnosis Test
Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
If all fuel injectors have been activated (clicks):
- Switch off ignition.
- Check injectors
Page 24-97
- Check DTC memory, repair Diagnostic Trouble
Codes (DTCs) if necessary and then erase DTC
memory
Page 01-23
, DTC memory, checking
and erasing.
- Read readiness code
Page 01-146
. If the
DTC memory has been erased or the Motronic
Engine Control Module (ECM) -J220- was
disconnected from battery (B+) positive, the
readiness code must be generated again
Page 01-149
.
- Press
button.
Output Diagnosis Test Mode
END
Indicated on display:
Output Diagnosis Test Mode (DTM)
01-144
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
Output Diagnosis Test Mode (DTM)
01-145
Readiness code
Function
The readiness code is an 8-digit number
code which displays the status of the
emission relevant diagnosis.
When the diagnosis for a system (e.g.
secondary air system) has been
successfully completed, the corresponding
position in the number code will change from
1 to 0.
The diagnosis is performed at regular
intervals during normal driving. It is
recommended that the readiness code be
generated after performing repairs on an
emission relevant system, to guarantee that
these systems function correctly. If a
malfunction is detected during the diagnosis
it will be stored in the DTC memory.
Each time the DTC memory is erased or the
voltage supply is interrupted the readiness
code will be erased.
Readiness code
01-146
Read readiness code
Special tools, workshop
equipment, testers, measuring
instruments and auxiliary items
required
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the
vehicle diagnostic, testing and
information system VAS 5051.
Work sequence
VAG 1551 Scan tool (or VAG
1552 vehicle system tester) with
VAG 1551/3 adapter cable
- Connect VAG 1551 scan tool
((VAG 1552) and select Engine
Control Module (ECM) with the
"Address word" 01. Engine must
be running at idle: (Connecting
scan tool and selecting Engine
Control Module (ECM)
Page
01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -1- and -5- for
function "Readiness code" and
confirm entry with -Q- button.
Readiness code
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст