Volkswagen Golf / Golf GTI / Jetta. Manual — part 203
24-66
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Checking voltage supply and wiring to
control module
- Connect multimeter to measure voltage at
connector terminals 2 (positive) and 6 (Ground
(GND)).
- Switch on ignition.
Specification: at least 4.5 V
- Switch off ignition.
If the specifications are not obtained:
- Connect multimeter to measure voltage at
connector terminal 2 (positive) and Ground
(GND).
- Switch on ignition.
Specification: at least 4.5 V
- Switch off ignition.
Components, checking
24-67
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment, Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open circuit
between test box socket and
connector referring to Electrical
Wiring Diagrams:
Terminal 1 and socket 92
Terminal 2 and socket 83
Terminal 3 and socket 117
Terminal 4 and socket 84
Terminal 5 and socket 118
Terminal 6 and socket 91
Wire resistance: max. 1.5
Components, checking
24-68
- Additionally check wiring for short to one
another, to vehicle Ground(GND) and to battery
positive.
Specification:
If no wiring malfunction is detected:
- Check Motronic Engine Control Module (ECM) -
J220- voltage supply
Page 24-163
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
24-69
Engine Coolant Temperature (ECT)
sensors -G62- and -G2-, checking
Note:
The Motronic Engine Control Module (ECM)
-J220- will use a replacement value for an
engine start (start temperature replacement
value) as soon as there is a Diagnostic
Trouble Code (DTC) stored in the DTC
memory, which affects the Engine Coolant
Temperature (ECT) sensor -G62-. The
temperature then rises according to a model
stored in the control module. When the
engine has reached normal working
temperature a fixed replacement value will
be displayed after a certain period.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст