Volkswagen Golf / Golf GTI / Jetta. Manual — part 201
24-58
- Additionally check wiring for short to one
another, to vehicle Ground(GND) and to battery
positive.
Specification:
If no wiring malfunction is detected:
- Replace Mass Air Flow (MAF) sensor -G70-
Page 24-30
, item 6 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
24-59
Throttle Valve Control Module -J338-,
checking
Note:
Only gold plated terminals may be used to
service the terminals in the connector of the
Throttle valve control module -J338-.
Components of Throttle valve control module -
J338-: Throttle drive (power accelerator
actuation) -G186-, Angle sensor -1- for throttle
drive (power accelerator actuation) -G187- and
Angle sensor -2- for throttle drive (power
accelerator actuation) -G188-.
Note:
If the Throttle valve control module -J338- is
replaced, the new control module must be
adapted to the Motronic Engine Control Module
(ECM) -J220-
Page 24-182
.
On vehicles installed with an automatic
transmission the transmission control module
must also be adapted:
Repair Manual, 4 Spd. Automatic
Transmission 01M On Board Diagnostic (OBD);
Repair Group 01
Components, checking
24-60
Special tools and equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 Test box
Electrical Wiring Diagrams
Components, checking
24-61
Test requirements
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Fuel Pump (FP) Relay -J17-
must be OK., checking:
Engine Coolant Temperature
(ECT) must be at least 85 C,
display group 1, display zone
2.
Throttle valve not damaged or
contaminated/dirty.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст