Volkswagen Golf / Golf GTI / Jetta. Manual — part 204
24-70
Special tools and equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
Test requirements
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 Test box
Electrical Wiring Diagrams
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Engine must be cold.
Components, checking
24-71
Test sequence
Note:
Only gold plated terminals may be used when
servicing the sensor connector terminals.
- Connect VAG 1551 Scan tool (or VAG 1552).
Then switch ignition on and select Motronic
Engine Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551 and Motronic
Engine Control Module (ECM) -J220-,
connecting and selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -0- and -4- for "Display group
number 4" and confirm entry with -Q- button.
Read measured value block 4
1
2
3
4
Indicated on display: (1 to 4
display zones)
- Read coolant temperature value in display zone
3.
Specification: approx. coolant temperature
Components, checking
24-72
If the specification is not obtained:
- Check according to following table:
Display
1)
Cause
Continuation of
check
Approx. -
42.0 C
Open circuit or
short to
positive
Page 24-74
Approx.
136.0 C
Short to Ground
(GND)
Page 24-76
1)
If a temperature is displayed which deviates
greatly from the ambient temperature of the
sensor, check sensor wiring for transfer
resistance.
If the specification is obtained:
- Start engine and run at idle speed. Temperature
value must increase uniformly
Note:
If irregular engine running occurs in certain
temperature ranges and the temperature figure
does not increase without interruption, the
temperature signal is temporarily interrupted and
the sensor must be replaced.
Components, checking
24-73
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
If the display does not indicate as described:
- Replace Engine Coolant Temperature (ECT)
sensor -G62- / Engine Coolant Temperature
(ECT) sensor -G2-
Page 24-16
, item 14 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст