Volkswagen Golf / Golf GTI / Jetta. Manual — part 241
24-218
Cruise Control System (CCS),
checking
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Additional signals, checking
24-219
Test requirements
Test sequence
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
- Connect VAG 1551 Scan tool (or
VAG 1552). Then switch ignition
on and select Motronic Engine
Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551
and Motronic Engine Control
Module (ECM) -J220-, connecting
and selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for
function "Read measured value
(data) block" and confirm entry
with -Q- button.
Additional signals, checking
24-220
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -6- and -6- for
"Display group number 66" and
confirm entry with -Q- button.
Read measured value block 66
1
2
3
4
Indicated on display: (1 to 4
display zones)
Vehicles with an automatic
transmission
Observe the valid safety precautions
when performing a road test
Page
24-33
.
- Perform a road test and exceed a
speed of 25 km/h once then
switch engine off and leave
selector lever in position 2, 3, or
D.
- Apply parking brake.
Additional signals, checking
24-221
Continuation for all vehicles
- Check specification for switch
position of CCS operating switch
in display zone 4.
Test requirements
Display
zone 4
Switch B at "OFF", in
detent
xxxxxxx0
Switch B at "OFF", in
detent or not in
detent
xxxxxx0x
Switch B at "ON"
xxxxxx11
Switch A depressed
(Switch B at "ON")
xxxxx111
Switch B at "RES"
xxxx1xxx
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст