Volkswagen Golf / Golf GTI / Jetta. Manual — part 239
24-210
If the specifications are obtained:
If the specification is not obtained:
If the specification is obtained:
If the specification is not obtained:
- Connect multimeter to measure
voltage between terminal 1 and
Ground (GND).
Specification: at least 11.5 V
- Check wiring connections to fuse
holder for open circuit referring to
Electrical Wiring Diagrams.
Wire resistance: max. 1.5
- Connect multimeter to measure
voltage between terminal 2 and
Ground (GND).
- Switch on ignition.
Specification: at least 11.5 V
- Switch off ignition.
- Check wire for open circuit
between 4-pin connector terminal
2 and Fuel Pump (FP) Relay -
J17- referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
Additional signals, checking
24-211
If the specification is obtained:
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open circuit
between test box and 4-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 3 and socket 55
Terminal 4 and socket 56
Wire resistance: max. 1.5
- Additionally check wiring for short
to one another, to vehicle Ground
(GND) and to battery positive.
Specification:
Additional signals, checking
24-212
If there is no Diagnostic Trouble Code (DTC) in
the wiring and the resistance measurement
values are OK.:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
24-213
Transmission Range signal,
checking
Vehicles with an automatic transmission
The Motronic Engine Control Module (ECM)
-J220- receives the following information
from the transmission control module:
Driving range selected (selector lever in
2/3/4/R/D)
or
No transmission range selected (selector
lever in P or N)
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст